Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until June, 2020.

  1. Dual Plane 3D Compton Scattering Imager with Pixelated CZT Detectors for 1-10MeV Gamma Ray

    SBC: H3D            Topic: None

    Phase I has proven that the current setup achieves better than 8mm spatial resolution for 2.2MeV prompt gammas. However, 1mm spatial resolution presents a significant challenge for the current setup due in part to limited timing resolution and count rate. A new analog ASIC will be developed to replace the current analog ASIC that will have better timing resolution and deliver higher count rates. I ...

    SBIR Phase II 2019 Department of CommerceNational Institute of Standards and Technology
  2. Advanced Instrumentation for Non-Nulling Stack Velocity Testing

    SBC: AIRFLOW SCIENCES CORPORATION            Topic: None

    Industrial facilities, manufacturing plants, and electric power plants that burn fossil fuels exhaust the combustion products to atmosphere through their smokestacks. Stack pollutant emissions are quantified using manual testing methods developed in the 1960s, which are prone to error if non-axial flow exists in a stack.Recently, NIST has been working on an improved technique of performing 3D flow ...

    SBIR Phase I 2019 Department of CommerceNational Institute of Standards and Technology
  3. Development of a Neutron-based Nondestructive Test Method for Concrete Petrography and Chemical Analysis

    SBC: TOURNEY CONSULTING GROUP, LLC            Topic: None

    To evaluate the technical feasibility of prompt gamma neutron activation (PGAA) as an alternative to a set of standard destructive tests of concrete petrography including aggregate type, water/cement ratio, aggregate/binder ratio, density, chloride content and chloride bulk diffusion constant; and to determine the specifications for the design of a dedicated commercial laboratory-based PGAA facili ...

    SBIR Phase I 2019 Department of CommerceNational Institute of Standards and Technology
  4. Ultra High Sensitivity SWIR Methane Imaging Camera

    SBC: Amethyst Research Incorporated            Topic: 861X

    Methane, is the third most prevalent greenhouse gas whose atmosphere concentration is currently over 1.7 ppm. Methane is about 21 times more potent when compared to CO2. Even though its concentration in the atmosphere is more than 200 times lower than carbon dioxide, methane is responsible for 20% of the greenhouse effect. The main natural resources for methane include wetlands, termites and the o ...

    SBIR Phase I 2015 Department of CommerceNational Oceanic and Atmospheric Administration
  5. Combined Extinction/Fluorescence Absorption Diagnostics for Sprays

    SBC: En'urga Inc.            Topic: 9030163R

    This Phase II project will continue the prototype development of a pharmaceutical spray quality audit system. The spray quality audit system will estimate the planar mass distribution, mass flux, and drop size of pharmaceutical sprays that are used in functional coating applications and inhalers. A prototype tomography system will be designed and fabricated and evaluated using various fluorophore.

    SBIR Phase II 2015 Department of CommerceNational Institute of Standards and Technology
  6. Large-Area, High-Uniformity Photodiodes for Infrared Trap Detectors

    SBC: Amethyst Research Incorporated            Topic: 9020168R

    methyst Research Inc. will design, fabricate and test a high uniformity, large area, low noise infrared trap-detector detector for the 1- 4.5 μm wavelength range. This state of the art detector will have a large area (e.g., 1-1.8 cm diameter active area) with a spatial variability of internal quantum efficiency of less than 0.1 % between 1 μm and 4.5 μm. In addition, the internal quantum effici ...

    SBIR Phase I 2015 Department of CommerceNational Institute of Standards and Technology
  7. Optimized CO2 Gas Sensor for Autonomous Measurement of Ocean Carbon

    SBC: DIOXIDE MATERIALS, INC.            Topic: 822R

    The objective of the proposed work is to create low cost, low power sensors for autonomous measurement of ocean carbon. In our Phase I effort, we showed that Dioxide Materials’ miniature CO2 sensors have the speed and sensitivity to meet NOAA’s requirements for sensing ocean carbon. The objective of the proposed work is to further develop the sensors so that they can be used directly in NOAA ...

    SBIR Phase II 2015 Department of CommerceNational Oceanic and Atmospheric Administration
  8. MOTION COMPENSATING SCALE

    SBC: General Oceanics Inc            Topic: N/A

    THE AIM OF THIS PROJECT IS TO DEVELOP A SCALE FOR WEIGHING LOADS OF UP TO 100 KG. ON MOVING PLATFORMS SUCH AS SHIPS. THE PROBLEM IN THESE SITUATIONS IS THAT ACCELERATION FORCES GENERATED BY THE MOTION OF THE VEHICLE CONSTANTLY VARY THE APPARENT WEIGHT OF ANY OBJECT RESTING ON THE SCALE. THE SOLUTION PROPOSED HERE IS TO USE AN ELECTRONIC SCALE AND COMBINE ITS ELECTRICAL OUTPUT SIGNAL WITH SIGNALS F ...

    SBIR Phase I 1987 Department of Commerce
  9. LOW COST HRPT DIRECT READOUT STATION

    SBC: International Systems & Soft-            Topic: N/A

    THIS ABSTRACT COVERS THE PROPOSED DESIGN OF A LOW COST HRPT DIRECT READOUT STATION FOR A COST OF LESS THAN $100K DOLL ARS. THIS CONCEPT UTILIZES STATE-OF-THE-ART TECHNOLOGY PROVEN SUCCESSFUL IN COMMERCIAL APPLICATIONS. THE SUCCESSFULDEVELOPMENT OF THE LOW-COST HRPT STATION WILL OPEN A COMMERCIAL AND GOVERNMENT MARKET THAT HAS A NEED FOR CURRENT WEATHER INFORMATION. THESE POTENTIAL USERS HAVE DELAY ...

    SBIR Phase II 1987 Department of Commerce
  10. Decision Support Tools for Sustainable Manufacturing

    SBC: BIMCON Inc.            Topic: N/A

    The objective of this proposal is to establish the feasibility of developing an integrated decision support tool that transforms the current time-consuming and reactive (post-design) sustainability assessment into a real-time, proactive approach available in the early phases of product design. This tool, called Sustainability Integrated into Early Design (SIED), will define and capture lifecycle-w ...

    SBIR Phase I 2010 Department of CommerceNational Institute of Standards and Technology
US Flag An Official Website of the United States Government