Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until September, 2020.

  1. Dual Plane 3D Compton Scattering Imager with Pixelated CZT Detectors for 1-10MeV Gamma Ray

    SBC: H3D            Topic: None

    Phase I has proven that the current setup achieves better than 8mm spatial resolution for 2.2MeV prompt gammas. However, 1mm spatial resolution presents a significant challenge for the current setup due in part to limited timing resolution and count rate. A new analog ASIC will be developed to replace the current analog ASIC that will have better timing resolution and deliver higher count rates. I ...

    SBIR Phase II 2019 Department of CommerceNational Institute of Standards and Technology
  2. Advanced Instrumentation for Non-Nulling Stack Velocity Testing

    SBC: AIRFLOW SCIENCES CORPORATION            Topic: None

    Industrial facilities, manufacturing plants, and electric power plants that burn fossil fuels exhaust the combustion products to atmosphere through their smokestacks. Stack pollutant emissions are quantified using manual testing methods developed in the 1960s, which are prone to error if non-axial flow exists in a stack.Recently, NIST has been working on an improved technique of performing 3D flow ...

    SBIR Phase I 2019 Department of CommerceNational Institute of Standards and Technology
  3. Development of a Neutron-based Nondestructive Test Method for Concrete Petrography and Chemical Analysis

    SBC: TOURNEY CONSULTING GROUP, LLC            Topic: None

    To evaluate the technical feasibility of prompt gamma neutron activation (PGAA) as an alternative to a set of standard destructive tests of concrete petrography including aggregate type, water/cement ratio, aggregate/binder ratio, density, chloride content and chloride bulk diffusion constant; and to determine the specifications for the design of a dedicated commercial laboratory-based PGAA facili ...

    SBIR Phase I 2019 Department of CommerceNational Institute of Standards and Technology
  4. A Portable Vibrio Cholerae Concentrator for Sensitive Pathogen Detection in Water

    SBC: OMNIVIS INC            Topic: None

    This SBIR Phase I project proposes to develop an easy to use, inexpensive, and portable bacterial concentrator to enable more sensitive cholera pathogen (Vibrio cholerae) detection. Cholera affects communities across 41 countries, including Mozambique in 2019 after Cyclone Idai and Yemen in 2017. Current methods used to detect the cholera pathogen in water involves a 3 to 5-day procedure due to th ...

    SBIR Phase I 2019 Department of CommerceNational Institute of Standards and Technology
  5. Combined Extinction/Fluorescence Absorption Diagnostics for Sprays

    SBC: En'urga Inc.            Topic: 9030163R

    This Phase II project will continue the prototype development of a pharmaceutical spray quality audit system. The spray quality audit system will estimate the planar mass distribution, mass flux, and drop size of pharmaceutical sprays that are used in functional coating applications and inhalers. A prototype tomography system will be designed and fabricated and evaluated using various fluorophore.

    SBIR Phase II 2015 Department of CommerceNational Institute of Standards and Technology
  6. Large-Area, High-Uniformity Photodiodes for Infrared Trap Detectors

    SBC: Amethyst Research Incorporated            Topic: 9020168R

    methyst Research Inc. will design, fabricate and test a high uniformity, large area, low noise infrared trap-detector detector for the 1- 4.5 μm wavelength range. This state of the art detector will have a large area (e.g., 1-1.8 cm diameter active area) with a spatial variability of internal quantum efficiency of less than 0.1 % between 1 μm and 4.5 μm. In addition, the internal quantum effici ...

    SBIR Phase I 2015 Department of CommerceNational Institute of Standards and Technology
  7. Decision Support Tools for Sustainable Manufacturing

    SBC: BIMCON Inc.            Topic: N/A

    The objective of this proposal is to establish the feasibility of developing an integrated decision support tool that transforms the current time-consuming and reactive (post-design) sustainability assessment into a real-time, proactive approach available in the early phases of product design. This tool, called Sustainability Integrated into Early Design (SIED), will define and capture lifecycle-w ...

    SBIR Phase I 2010 Department of CommerceNational Institute of Standards and Technology
  8. Combined Extinction/Flourescence Absorption Diagnostics for Pharmaceutical Sprays

    SBC: En'urga Inc.            Topic: 9030163R

    This Phase I project will evaluate the feasibility of a pharmaceutical spray quality audit system. The spray quality audit system will estimate the mass distribution of active ingredients and droplet sizes in pharmaceutical sprays using combined fluorescence absorption and light extinction tomography. En’Urga will modify an existing instrument to simultaneously obtain full volume fluorescence ab ...

    SBIR Phase I 2014 Department of CommerceNational Institute of Standards and Technology
  9. Scale-Up of ATPE Technology to Produce Highly Enriched Semiconducting SWCNTs

    SBC: SouthWest NanoTechnologies (SWeNT)            Topic: N/A

    Single-walled carbon nanotubes (SWCNTs) have unique material properties making them very attractive for use in a variety of electronic applications. However, as-grown SWCNTs contain a mixture of tubes with heterogeneous optical and electronic properties. The chiral species must be separated in order to maximize the desired properties. To date, no large scale separation process has been accomplishe ...

    SBIR Phase I 2014 Department of CommerceNational Institute of Standards and Technology
US Flag An Official Website of the United States Government