Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until June, 2020.

  1. Active Mixing of Polymers in a Dispensing Head

    SBC: nScrypt, Inc.            Topic: N/A

    A method to take three polymers with varying viscosities and mixing those polymers together at the point of interest or more specifically through a micro dispensing nozzle, is being proposed. An active mixing scheme to ensure proper mixing at the pen tip is a feasible approach to this problem. The materials being mixed will not only range in viscosity but also in particle loading, which will be ha ...

    SBIR Phase I 2005 Department of CommerceNational Institute of Standards and Technology
  2. Ultra-High Vacuum Compatible Wavelength Dispersive X-ray Spectrometer

    SBC: PARALLAX RESEARCH INC            Topic: N/A

    Parallax Research, Inc. proposes to build an Ultra-High Vacuum compatible Wavelength Dispersive X-ray Spectrometer (WDS) that can be used on small spot Auger, XPS, TEM and FESEM analytical instruments for elemental analysis. The effort draws upon Parallax's experience in designing WDS systems for Scanning Electron Microscopes (SEM) and for XRF. This new type of x-ray spectrometer will eliminate th ...

    SBIR Phase II 2005 Department of CommerceNational Institute of Standards and Technology
  3. Low-Cost Microcalorimeter Spectrometer for X-Ray Macroanalysis

    SBC: STAR CRYOELECTRONICS LLC            Topic: N/A

    A low-cost superconducting transition edge sensor (TES) microcalorimeter spectrometer is described for high energy and high spatial resolution X-ray energy dispersive spectroscopy and microanalysis. The proposed microcalorimeter instrument offers an energy resolution that is comparable to and potentially even better than wavelength dispersive spectrometers, thereby enabling the resolution of inter ...

    SBIR Phase II 2005 Department of CommerceNational Institute of Standards and Technology
  4. Distributed Automatic Reconifigurable Transponder (DART)

    SBC: WILLIAMSRDM, INC.            Topic: N/A

    his proposal focuses on developing Distributed Automatic Reconfigurable Trasponder (DART) system that is capable of achieving distributed multi-nodal voice/data communication for firefighters. Specifically, Williams-Pyro, Inc. proposes to develop an enhanced prototype of distributed Automated Reconfigurable Intelligent Radios, which consists of a series of distributed nodes that will relay voice t ...

    SBIR Phase I 2005 Department of CommerceNational Institute of Standards and Technology
  5. Fulcrum Biometrics' Plan for Research and Development of WS-BD Conformant Handheld Fingerprint Sensor

    SBC: Fulcrum Biometrics, LLC            Topic: N/A

    Trusted biometric validation of individual identities has never been more important. Several contributing factors are the increase in global terrorism, identity theft and the increase in legislation which are driving the accelerated adoption of biometric technology. Unfortunately, the biometrics industry has not actively responded to the changing market conditions being driven by the explosion in ...

    SBIR Phase I 2012 Department of CommerceNational Institute of Standards and Technology
  6. Improved Microcalorimeter Detectors for X-Ray Chemical Shift Mapping

    SBC: STAR CRYOELECTRONICS LLC            Topic: N/A

    X-ray fluorescence spectroscopy is a widely used and extremely sensitive analytical technique for qualitative as well as quantitative chemical analysis. Superconducting Transition Edge Sensor (TES) microcalorimeter detectors have now been developed that achieve an energy resolution of 2 eV (full width at half maximum) for 1.5 keV X-rays, which is sufficient to enable the measurement of the small s ...

    SBIR Phase I 2012 Department of CommerceNational Institute of Standards and Technology
  7. Large-Area, High-Uniformity Photodiodes for Infrared Trap Detectors

    SBC: AMETHYST RESEARCH INCORPORATED            Topic: 9020168R

    methyst Research Inc. will design, fabricate and test a high uniformity, large area, low noise infrared trap-detector detector for the 1- 4.5 μm wavelength range. This state of the art detector will have a large area (e.g., 1-1.8 cm diameter active area) with a spatial variability of internal quantum efficiency of less than 0.1 % between 1 μm and 4.5 μm. In addition, the internal quantum effici ...

    SBIR Phase I 2015 Department of CommerceNational Institute of Standards and Technology
  8. Cognitive Residential Heat Pumps Fault Detection and Diagnostic Datalogger

    SBC: MANAGEMENT SCIENCES INC            Topic: 9010173R

    During Phase I, Management Sciences, Inc. (MSI) proved feasibility of adapting their current technology into a product capable of improving performance resulting in increased efficiency and extended life cycles of heat pumps. The resultant product is a tool named the Heat Pump Sentient (HP-Sentient). The HP-Sentient will improve performance and reduce maintenance costs through aggressive goal-seek ...

    SBIR Phase II 2015 Department of CommerceNational Institute of Standards and Technology
  9. Precision 10 kV Programmable Voltage Source

    SBC: Low Thermal Electronics, Inc.            Topic: NA

    Low Thermal Electronics, Inc. proposes to design a stand-alone, programmable voltage source capable of supplying precision voltages in the range of zero to 1,000 volts direct current (DC), with options for scaling up to 10,000 volts, and with a total expanded uncertainty (k=2) of less than 10uV/V for the 10,000 volt version. This instrument will improve state-of-the-art measurements in high resist ...

    SBIR Phase I 2017 Department of CommerceNational Institute of Standards and Technology
  10. Advanced Manufacturing and Material Measurements Software Tool Weave ™ for the Acceleration and Automation of SEM Image Analysis in the Semiconductor Industry

    SBC: Sandbox Semiconductor Incorporated            Topic: None

    In this Phase I SBIR proposal, SandBox Semiconductor™ proposes to develop an Advanced Manufacturing and Material Measurements software tool called Weave ™ for accelerating and automating SEM image analysis for the semiconductor industry. During the development of a new manufacturing process line for a semiconductor device, tens of thousands of scanning electron microscopy (SEM) images are take ...

    SBIR Phase I 2019 Department of CommerceNational Institute of Standards and Technology
US Flag An Official Website of the United States Government