You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY20 is not expected to be complete until September, 2021.

  1. A Ruggedized System for Measuring Extreme Winds

    SBC: Caregiver Technologies, Inc.            Topic: N/A

    We will develop technology, termed a Ruggedized Wind Measurement System (RWMS), to measure directly extreme winds with high space and time resolution, focusing on the winds that occur beneath hurricanes at land fall. This development effort will include design, fabrication of two prototype RWMS units, and a series of proof-of-concept demonstrations in strong mountain-induced downslope and severe t ...

    SBIR Phase I 1997 Department of Commerce
  2. A HIGH RESOLUTION CDTE ARRAY MONITORING SYSTEM FOR MONITORING CONTAMINATION IN SOILS

    SBC: Radiation Safety Engineering, Inc.            Topic: N/A

    N/A

    SBIR Phase I 1994 Nuclear Regulatory Commission
  3. Diode Laser-Based Optical Flux Monitor for MBE Control

    SBC: Southwest Sciences, Inc.            Topic: N/A

    A diode laser method for the real-time measurement of absolute flux concentrations and spatial profiles of atomic beams used in MBE will be tested. The proposed method uses the doubled output of a near-infrared diode laser to access atomic absorption lines of species such as Ga, Al and In. The detection method will combine high frequency wavelength modulation and noise canceler approaches in order ...

    SBIR Phase I 1997 Department of Commerce
  4. Sensitive Measurement of Water Vapor from Commercial Aviation Platforms

    SBC: Southwest Sciences, Inc.            Topic: N/A

    Commercial aviation offers a low cost platform from which to make extensive humidity measurements, provided the instrumentation can run autonomously and endure the rigorous flight schedules. Advances in state of the art diode laser gas sensing technology make possible compact, fully automated, self-calibrating instrumentation with the sensitivity needed to measure humidity levels throughout the tr ...

    SBIR Phase I 1997 Department of Commerce
  5. A Diode Laser Multigas Analyzer for Advanced Detection of Fires

    SBC: Southwest Sciences, Inc.            Topic: N/A

    N/A

    SBIR Phase I 1996 Department of Commerce
  6. DIODE LASER ABSOLUTE MOISTURE SENSOR

    SBC: Southwest Sciences, Inc.            Topic: N/A

    N/A

    SBIR Phase I 1994 Department of Commerce
  7. Development of A1203 Detector Material and OSL Dosimetric Technique for

    SBC: Stillwater Sciences, L.L.C.            Topic: N/A

    This proposal describes a new research program to be established at the small business Still Sciences, LLC, in collaboration with Department of Physics of Oklahoma State University. The overall goal is to develop and commercialize an all-optical dosimetry system for industrial radiation processing based on a novel Pulsed Optically Stimulated Luminescence readout technique and a new Al2O3 material ...

    SBIR Phase I 1997 Department of Commerce
  8. ELECTROMAGNETIC ENVIRONMENTAL EFFECTS WITHIN A NUCLEAR POWER PLANT

    SBC: MISSION RESEARCH CORP.            Topic: N/A

    MRC PROPOSES TO DEVELOP A SAFETY PERFORMANCE INDICATOR (PI) OF THE ELECTROMAGNETIC (EM) PROTECTION STATUS OF A NUCLEAR POWER PLANT (NPP). WE BELIEVE THAT SUCH A PI IS NEEDED BECAUSE: (1) EM ENVIRONMENTAL POLLUTION IS ON THE INCREASE,(2) ADDITIONAL EM THREATS MUST BE EVALUATED, AND (3) DISRUPTION OF NPP OPERATIONS BY EM EFFECTS CAN AND MUST BE AVOIDED. PREVIOUS STUDIES HAVE ADDRESSED THE ISSUE OF E ...

    SBIR Phase I 1990 Nuclear Regulatory Commission
  9. Thermographic Phosphor Based Heat Flux Sensors

    SBC: KTECH CORP.            Topic: N/A

    As fire protection engineering moves towards the implementation of performance- based fire codes, the use of validated fire models is becoming a necessity. Part of the validation process involves demonstrating model capabilities for predicting key fire environment parameters. One of the key parameters for estimating time to ignition and fire growth is the heat transfer rate to compartment surfaces ...

    SBIR Phase I 1997 Department of Commerce
  10. New Methods for Evaluating Thermal Performance of Protective Clothing for

    SBC: KTECH CORP.            Topic: N/A

    A growing number of fire fighters are suffering third degree burns; this has led to questions about the adequacy of thermal protective performance (TPP) measurements for protective clothing. A new heat flux sensor, whose response approximates that of skin, will be developed to provide better measurements of heat transfer in TPP tests. This sensor will be used with nonlinear parameter estimation an ...

    SBIR Phase I 1997 Department of Commerce
US Flag An Official Website of the United States Government