You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY20 is not expected to be complete until September, 2021.

  1. A Compact X-Ray Laser

    SBC: Tetra Corporation            Topic: N/A

    The advanced technology described in this proposal promises to increase the performance of laboratory and, specifically, tabletop x-ray lasers by up to an order of magnitude. Such gains in performance coupled with compact technology will lead to the introduction of the world s first table-top, commercial x-ray laser. Tetra proposes to develop an advanced driver for the laboratory laser based upo ...

    SBIR Phase I 1996 Department of DefenseMissile Defense Agency
  2. Active Mode Millimeter Wave Imaging

    SBC: K&c Tech., Inc.            Topic: N/A

    This proposal addresses an approach to millimeter wave imaging called encoded image detection (EID). The concept offers a means of achieving a low cost, all weather seeker for smart munition and submunitions. Its low cost potential makes adaptation of the imager also attractive for a variety of other military applications such as search and rescue, surveillance, and security. Most current devel ...

    SBIR Phase I 1996 Department of DefenseMissile Defense Agency
  3. Active Multi-Functional Polymeric Material With Modulation, Switching, and Amplification Capabilities

    SBC: RADIANT RESEARCH, INC.            Topic: N/A

    The achievement in realizing low-loss waveguides on any surface of interests using photolime gel polymer motivates us to further investigate the feasibility of employing such a unique material as a multi-functional polymer that can provide modulation, switching, wavelength conversion and amplification simultaneously on any optoelectronic substrate of interest. In this program, we propose to resear ...

    SBIR Phase I 1997 Department of DefenseMissile Defense Agency
  4. Active Suppression of Thruster Induced Seeker Jitter Using Electro-

    SBC: PROPULSION RESEARCH, INC.            Topic: N/A

    SEEKER STABILIZATION VIBRATION SUPPRESSION ELECTRO-ACTIVE MATERIALS PROPULSION RESEARCH WILL USE ITS MINIATURE "FERRO-MAGNETIC" ACTUATOR EFFORTD CAN BE USED TO CREATE A "SEEKER ANTI-MOTION SYSTEM". THIS TECHNOLOGY TAKES AN AGGRESSIVE APPROACH TOWARD "INTELLIGENTLY" MANAGING THE SEEKER DYNAMIC RESPONSE TO INDUCED MOTION BY ISOLATING IT "DYNAMICALLY" FROM THE REAMINDER OF THE AIRFRAME USING ELECTRO- ...

    SBIR Phase I 1994 Department of DefenseMissile Defense Agency
  5. Advanced Metal Powder Manufacture for MLCC Applications

    SBC: NANOCHEM RESEARCH, INC.            Topic: N/A

    Sensors, capacitors, and conducting features such as resistors and capacitors on circuit boards are produced from metal and ceramic powders 1-12 These powders are manufactured by liquid phase precipitation routes which often start with reduction of metal salts or by solid-state routes where solid reactants are mixed, heated and then milled. The solid-state processing is generally repeated several ...

    SBIR Phase I 1997 Department of DefenseMissile Defense Agency
  6. Advanced Projectile Diverters for Strategic Defense and Theater Missile Defense Miniature Interceptor Applications

    SBC: Tg&c Assoc., Inc.            Topic: N/A

    This proposal addresses the exploratory development and evaluation of novel thin film and/or monolithic detonators as diverters for guided spinning projectile use. A number of such detonators comprise a diverter technology termed RMDM, (for Ring Matrix Diverter Module) which, along with the SSPG (for Small Spinning Projectile Guidance) seeker, forms the basis for inexpensive miniature guided proje ...

    SBIR Phase I 1997 Department of DefenseMissile Defense Agency
  7. A FUEL/AIR DRIVE FLUX COMPRESSOR POWER UNIT FOR ELECTROTHERMAL GUNS

    SBC: KTECH CORP.            Topic: N/A

    The Ktech Team proposes a feasibility study of a fuel/air driven flux compression power unit (FCPU) for electric guns. Through variations of inductance gradients and through changes in scale, the proposed technology will be applicable to both electrothermal/chemical and electromagnetic guns. In the Phase 1 effort, we develop simulation models to predict the performance of the flux compression po ...

    SBIR Phase I 1996 Department of DefenseDefense Threat Reduction Agency
  8. A HIGH RESOLUTION CDTE ARRAY MONITORING SYSTEM FOR MONITORING CONTAMINATION IN SOILS

    SBC: Radiation Safety Engineering, Inc.            Topic: N/A

    N/A

    SBIR Phase I 1994 Nuclear Regulatory Commission
  9. A Novel High Thermal Conductivity, Low CTE, Low Weight MMC Substrate for Microelectronics Packaging

    SBC: ATS-MER, LLC            Topic: N/A

    This Small Business Innovation Research Phase I program proposes the development of a high thermal conductivity (470-550 W/mK), low coefficient of thermal expansion (5-8 ppm/K), and low weight (2.9-4.3 g/cc) Cu based metal matrix composite material to produce high performance substrates for microelectronics packaging. The proposed MMC system uses copper as the continuous metal matrix and cubic bor ...

    SBIR Phase I 1997 Department of DefenseMissile Defense Agency
  10. AN YTTRIUM ALUMINUM PEROVSKITE BASED GAMMA-RAY DOSIMETER

    SBC: W Peter Trower Inc.            Topic: N/A

    N/A

    SBIR Phase I 1994 Nuclear Regulatory Commission
US Flag An Official Website of the United States Government