Award Data

The advanced technology described in this proposal promises to increase the performance of laboratory and, specifically, tabletop x-ray lasers by up to an order of magnitude. Such gains in performance coupled with compact technology will lead to the introduction of the world s first table-top, commercial x-ray laser. Tetra proposes to develop an advanced driver for the laboratory laser based upo ...

This proposal addresses an approach to millimeter wave imaging called encoded image detection (EID). The concept offers a means of achieving a low cost, all weather seeker for smart munition and submunitions. Its low cost potential makes adaptation of the imager also attractive for a variety of other military applications such as search and rescue, surveillance, and security. Most current devel ...

The achievement in realizing low-loss waveguides on any surface of interests using photolime gel polymer motivates us to further investigate the feasibility of employing such a unique material as a multi-functional polymer that can provide modulation, switching, wavelength conversion and amplification simultaneously on any optoelectronic substrate of interest. In this program, we propose to resear ...

Sensors, capacitors, and conducting features such as resistors and capacitors on circuit boards are produced from metal and ceramic powders 1-12 These powders are manufactured by liquid phase precipitation routes which often start with reduction of metal salts or by solid-state routes where solid reactants are mixed, heated and then milled. The solid-state processing is generally repeated several ...

This proposal addresses the exploratory development and evaluation of novel thin film and/or monolithic detonators as diverters for guided spinning projectile use. A number of such detonators comprise a diverter technology termed RMDM, (for Ring Matrix Diverter Module) which, along with the SSPG (for Small Spinning Projectile Guidance) seeker, forms the basis for inexpensive miniature guided proje ...

This Small Business Innovation Research Phase I program proposes the development of a high thermal conductivity (470-550 W/mK), low coefficient of thermal expansion (5-8 ppm/K), and low weight (2.9-4.3 g/cc) Cu based metal matrix composite material to produce high performance substrates for microelectronics packaging. The proposed MMC system uses copper as the continuous metal matrix and cubic bor ...

MicroFab Research (MFR, Inc.) proposes to apply the techniques of micromachining to aid in the fabrication of millimeter wave components, thereby reducing manufacturing expenses. Many microwave applications such as radar and communication systems would be improved by shifting to higher frequencies, provided new lower cost manufacturing techniques can be found. A manufacturing technique is presente ...

AN ARRAY COMMUNICATIONS COPROCESSOR (ACC) ARCHITECTURE HAS BEEN DEVELOPED THAT PROVIDES AUTOMATIC, ADAPTIVE, AND DYNAMICALLY CONFIGURABLE INTER-PROCESSOR COMMUNICATIONS AND IS COMPATIBLE WITH MOST COMMERCIALLY AVAILABLE STATE-OF-THE-ART COMPLEX INSTRUCTION SET COMPUTERS (CISC) AND REDUCED INSTRUCTION SET COMPUTERS (RISC). IN THIS INVESTIGATION, THE ARRAY COMMUNICATIONS CONTROLLER IS BEING IMPLEMEN ...

Solid-state electronic devices are often subjected to high voltage transients generated by switching, lightning, or electrostatic discharge. These transients can cause mission critical components to fail. Varistors are increasingly used to avoid such failures. The current varistor devices, however, are not well suited for high frequency applications and the increasing trend towards device miniatur ...

BMDO seeks development of novel low-to-no outgassing joining/bonding techniques for advanced composites. Explosive welding, employing actual chemical explosives, is a versatile process that can be used, in principle, with any two materials. In some situations involving difficult materials, explosive bonding is the only practical joining method. Typically, a layer of explosive is carefully coated o ...