Award Data

N/A

Optomec Design Company proposes to use Laser Engineered Net Shaping (LENSTM), a Rapid Prototyping and Manufacturing (RP&M) technology currently under development at Sandia National Laboratories (SNL), as a new method for integrating instrumentation (e.g., embedded sensors) into metal structural components. SNL has demonstrated the ability of the LENSTM technology to produce near net shape stainles ...

Silicon carbide materials will revolutionize semiconductor devices for military and commercial markets. The material's wide bandgap, high electric field breakdown, high thermal conductivity give SiC capabilities that far exceed those of silicon or gallium arsenide. Despite significant progress in silicon carbide development, fundamental defects--most prominently micropipes--persist. If SiC is to s ...

The properties of single-crystal silicon carbide are such that electronics devices from this material have demonstrated remarkable performance characteristics. Despite the material's promise, the material has not yet found acceptance in mainstream device markets because of the material's high cost, among other reasons. This Phase I SBIR proposes an SiC source powder with unique properties which wi ...

A novel technological approach was recently devised by Sumi Tech engineers to fabricate multilayer electronic components, which enables the manufacture of devices with very high volumetric efficiency and reliability. Inexpensive electrode materials such as copper, or aluminum are potential candidates, since the process takes place at relatively low ambient temperature (e.g., less than 400 C), thus ...

A substantial effort has been devoted to finding a gamma-ray detector that can achieve a high count rate with high sensitivity and provide good energy resolution while operating at room temperature. Room temperature operation avoids the need for expensive and cumbersome cryogenic technology. This need for cryogenics is especially constraining in the need for portable detectors in remote locations, ...

The objective of this research is to demonstrate the feasibility of spray forming aluminum Metal Matrix Composites (MMC) in the solid-state physical form as a light weight structural material. It is anticipated that this innovative manufacturing process will provide opportunities to fabricate near-net-shape spacecraft and interceptor structures with unique material properties. The process called S ...

We propose to develop a novel and ambitious tool for large-scale development: a fourth-generation computer language (4GL) based upon an object-oriented generalization of the hierarchical block diagram paradigm, with powerful integrated simulation capabilities. Developers would assemble a prototype in a connect-the-blocks visual programming environment, test and evaluate it via simulation, then ite ...

We propose to develop and commercialize a Laser Assisted Molecular Beam Deposition (LAMBD) process for the growth of single crystal lattice matched CeO2 thin films on a Si substrate and thin film Si on CeO2 for the development and commercialization of silicon-on-insulator (SOI) devices and potentially Si based optoelectronic devices. CeO2 is nearly lattice matched to Si (0.35% rnismatched), which ...

This Phase I project has two primary objectives. The first objective is to evaluate the feasibility of a fully ion implanted fabrication process based on the heterodimensional 2-D MESFET. The new device, the 2-D JFET, will have p+ ion implanted sidegates which laterally modulate a thin, highly doped n-type conducting channel. The 2-D JFET should have excellent high speed, low power characteristics ...