Award Data

A compact, high power pulse UV laser would find many immediate applications in a variety of fields including bio-sensing. high-density data storage, printing, photolithography, remote sensing and detection of explosive materials. In response to this need, CoreTek, Inc. proposes to develop and commercialize a compact, diode-pumped, micro-cavity UV laser to generate an optical pulse train of sub-nan ...

The advanced technology described in this proposal promises to increase the performance of laboratory and, specifically, tabletop x-ray lasers by up to an order of magnitude. Such gains in performance coupled with compact technology will lead to the introduction of the world s first table-top, commercial x-ray laser. Tetra proposes to develop an advanced driver for the laboratory laser based upo ...

N/A

New power semiconductor device performance is limited by cooling because high heat-flux cooling systems have not matched their increased power density. Therefore, real designs rarely achieve device ratings. American Superconductor (ASC) demonstrated CryoPower+, which cools a variety of power MOSFET topologies by direct immersion in coolants from 77-300K, with boiling where appropriate. CryoPower ( ...

Historically, the full aperture of a high energy laser mirror has been liquid cooled with enough coolant to handle the peak absorbed thermal flux load over the entire mirror. Previous high energy laser mirrors considered only highly conductive materials and cooling schemes which minimized thermal distortion. Then, the advent of very low absorption coatings and silicon optics provided a laser mirro ...

N/A

ACX proposes to develop durable and reliable conformal geometry actuator packages. These packages will have the ability to operate as linear actuators for motion control applications as well as to conform to structures with curved surfaces for applications requiring induced strain actuation. These packages provide a protective skin offering electrical isolation, and provide a means for integration ...

Sensors, capacitors, and conducting features such as resistors and capacitors on circuit boards are produced from metal and ceramic powders 1-12 These powders are manufactured by liquid phase precipitation routes which often start with reduction of metal salts or by solid-state routes where solid reactants are mixed, heated and then milled. The solid-state processing is generally repeated several ...

This proposal addresses the exploratory development and evaluation of novel thin film and/or monolithic detonators as diverters for guided spinning projectile use. A number of such detonators comprise a diverter technology termed RMDM, (for Ring Matrix Diverter Module) which, along with the SSPG (for Small Spinning Projectile Guidance) seeker, forms the basis for inexpensive miniature guided proje ...

The optical material requirements for high quality laser crystals continues to become more difficult to meet as new laser uses are developed. Ytterbium doped Yttrium Ortho-Vanadate (Yb3+:YVO4) single crystal material is a potential successor to Neodimium doped YAG (Nd:YAG) because of its higher laser gain, efficiency and multi-Sw power range potential. Foster-Miller has conceived of an innovative ...