Award Data

ACTA and Sandia National Laboratories propose to quantify and propagate substructure modeling uncertainty for reduced-order substructure models to higher levels of system assembly, thereby enabling predictive simulations of engineering designs with quantified margins and uncertainties for model-based flight qualification of complete spacecraft. A critical part of this process is the accurate mode ...

This NASA Phase I STTR effort will establish the feasibility of developing a compact broadband near to mid-IR programmable optical comb for use in laser based remote sensing and communications. The comb generator will use a waveguide-based optical parametric gain block technology that can have ultra wideband (>250nm) operation with very high gain (>25dB) in a very compact footprint. This approach ...

In providing an innovative solution to improving information technologies and health management systems, AGNC is proposing a significant technological achievement with the Advanced Structural Health Monitoring System for Comprehensive Real-Time Vehicle Characterization. During in-flight conditions, this system is able to not only provide the status of information such as regarding the flight envel ...

The process of aircraft design requires the integration of data from individual analysis of aerodynamic, structural, thermal, and behavioral properties of a flight vehicle. At present, there is no simple way to integrate the results of the analyses early in the design process. Aurora Flight Sciences and the Massachusetts Institute of Technology Aerospace Computational Design Laboratory propose to ...

Balcones Technologies, LLC proposes to adapt actively controlled suspension technology developed by The University of Texas at Austin Center for Electromechanics (CEM) for high performance off-road vehicles to address STTR 2009-1 Subtopic T1.02, Information Technologies for Intelligent Planetary Robots. In particular, our team will develop a concept design for an actively controlled ElectroMechan ...

Advanced pump inducer design technology that uses high inlet diffusion blades, operates at a very low flow coefficient, and employs a cavitation control and stability device. A preliminary scoping inducer test with this technology indicated a doubling of the suction specific speed capability over current inducers. A three to four fold increase over current technology is the goal of this research ...

Radioisotope Power Systems (RPS) are critical for future flagship exploration missions in space and on planetary surfaces. Small improvements in the RPS performance, weight, size, and/or reliability can have a dramatic effect on the scientific capability of the vehicle and the overall mission costs. Radioisotope Thermophotovoltaic (RTPV) energy converters are a particular type of RPS that direct ...

Advances in high power, photovoltaic technology has enabled the possibility of reasonably sized, high specific power, high power, solar arrays. New thin film solar arrays have demonstrated specific powers of over 4000 W/kg (exceeding the current SOA of ~130 W/kg). At high specific powers, power levels ranging from 50 to several hundred kW are feasible for communication satellites. Coupled with ...

The proposed innovation is the replacement of existing test stand and parking lot fixtures with current SSL LED technology. The replacement fixtures will reduce energy consumption, generate less heat and provide maintenance free operation for over 50,000 hours. An explosion-proof fixture is capable of containing an internal combustion event without allowing flames or hot gasses to escape to the s ...

This Small Business Innovation Research Phase I project is for the development of an asymmetric supercapacitor that will have improved energy density and cycle life. Supercapacitors that utilize an aqueous electrolyte are limited to a maximum voltage of 1 volt due to the decomposition of water. Methods used to increase voltage include use of an organic electrolyte, which introduces additional comp ...