List

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for the given year is not complete until April of the following year. Annual Reports data is a snapshot of agency reported information for that year and hence might look different from the live data in the Awards Information charts.

  1. Acoustic Plate Mode HIV Biosensor

    SBC: BIODE, INC.            Topic: N/A

    We will test the feasibility of a reusable electronic biosensor technology capable of detecting HIVdirectly in serum. This technology is based upon the merging of two relatively different technologieAcoustic Plate Mode (APM) micro sensors. This biosensor technology will be capable of providing a seof the patient antibody to HIV. Biosensor assays for other infectious disease agents could likewisec ...

    SBIR Phase I 1995 Department of Health and Human Services
  2. An Acoustic Plate Mode Sensor for Biowarfare Toxins

    SBC: BIODE, INC.            Topic: N/A

    N/A

    SBIR Phase I 1995 Department of DefenseArmy
  3. Demonstration of the Production of 60 Hz AC Power Directly From High Frequency Alternators Using Solid State Controls

    SBC: DIRIGO R&D, INC.            Topic: N/A

    This project seeks to demonstrate the derivation of 60 Hz AC power direct from the output of high frequency alternators through a novel use of solid state controls. The independence of output frequency engine/driver speed will be demonstrated. The ability of these alternators to handle reactive power loads at 60 Hz will be investigated. The potential for producing useful levels of MIL-STD (60 H ...

    SBIR Phase I 1995 Department of DefenseArmy
  4. EMBEDDED PAVEMENT STRESS SENSORS CONTAINING PIEZOELECTRIC COMPOSITES

    SBC: Fiber Materials, Inc.            Topic: N/A

    FIBER MATERIALS, INC. (FMI) PROPOSES SENSORS WHICH CAN BE EMBEDDED IN PAVEMENT TO MEASURE STRESS AND STRAIN FROM TRUCKS PASSING OVER AT SPEEDS UP TO 60 MPH. THESE SIMPLE, DURABLE SENSORS WILL BE MADE FROM PIEZOELECTRIC COMPOSITES WHICH ACT AS PASSIVE SENSORS AND DEVELOP A CHARGE PROPORTIONAL TO THE APPLIED PRESSURE. THE CHARGE IS CONVERTED TO A VOLTAGE WHICH IS RECORDED ON NEARBY EQUIPMENT. THE PH ...

    SBIR Phase II 1995 Department of Transportation
  5. Lightweight Ceramic Ablators

    SBC: Fiber Materials, Inc.            Topic: N/A

    Future atmospheric entry vehicles will require thermal protection materials/systems that are more durable, lower weight, combined with highly efficient protection from atmospheric heating. One low density material concept has been found to exhibit good ablation and in-depth thermal response under simulated entry conditions. This material is a low density carbon fiber reinforced carbon matrix with ...

    SBIR Phase II 1995 National Aeronautics and Space Administration
  6. Ultra Lightweight/High Performance Structural PEM Fuel Cell Electrodes

    SBC: Fiber Materials, Inc.            Topic: N/A

    This program will demonstrate the fabrication of ultra lightweight/high performance composite annular electrodes incorporating the reliability, via strength and toughness, necessary to facilitate efficient, simple assembly of low cost PEM fuel cells for lightweight extended duty cycle portable power sources. New and innovative composite manufacturing techniques will be employed which offer a low ...

    SBIR Phase I 1995 Department of DefenseArmy
  7. Low-Cost, High Temperature Rocket Nozzle Components

    SBC: Fiber Materials, Inc.            Topic: N/A

    N/A

    SBIR Phase I 1995 National Aeronautics and Space Administration
  8. Travelers Diarrhea and E Coli--Prevalence of Pilus AGS

    SBC: IMMUCELL CORPORATION            Topic: N/A

    N/A

    SBIR Phase I 1995 Department of Health and Human Services
  9. Electrochemical Sterilization of Dental Handpieces

    SBC: Maine Research and Technology Co, Inc            Topic: N/A

    There is an increased awareness of the possibility of disease transmission between patients as a reimproperly sterilized dental equipment. In particular there is an increased fear of the spread of thviruses. Thus a device for rapid, effective cold sterilization of dental handpieces would be usefulpatient. Our product will eliminate the need of chemical agents to achieve room temperature sterilizha ...

    SBIR Phase I 1995 Department of Health and Human Services
  10. Concentration Measurements of Biomolecules

    SBC: Maine Research and Technology Co, Inc            Topic: N/A

    Laser Induced Fluorescence (LIF) can be used as a diagnostic device in biology and medicine. In gendifficulties relating the fluorescence spectra to the concentration of the emitters within the tissuspecies, and in the possibility of destroying the molecules being probed if the wrong excitation wavthe problems associated with fluorescence can be eliminated by the use of Raman scattering. Raman tem ...

    SBIR Phase I 1995 Department of Health and Human Services

Agency Micro-sites

SBA logo
Department of Agriculture logo
Department of Commerce logo
Department of Defense logo
Department of Education logo
Department of Energy logo
Department of Health and Human Services logo
Department of Homeland Security logo
Department of Transportation logo
Environmental Protection Agency logo
National Aeronautics and Space Administration logo
National Science Foundation logo
US Flag An Official Website of the United States Government