You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY20 is not expected to be complete until September, 2021.

  1. Diamond-Like Nanocomposites (DLN) as a Protective, Wear Resistant Thin Film for'Sliding Electrical Contacts.

    SBC: ADVANCED REFRACTORY TECHNOLOGIES, INC.            Topic: N/A

    A novel coating technology is proposed for increased wear and improved li fe and reliability of commutator bars in electrical sliding devices found in manned and unmanned underwater vehlilles. Diamond-Like Nanocomposite (DLN) coatings represent a famil Of thiWrfilms that bxhibit unique combinations of technologically interesting properties including high adhesion to virtually any substrate (inclu ...

    SBIR Phase II 1998 Department of DefenseNavy
  2. Acoustic Interference Rejection

    SBC: Advanced Acoustic Concepts, Inc.            Topic: N/A

    This SBIR project will determine the feasilibility of acoustic interference rejection techniques for a submarine acoustic intercept system. The signal processing techniques developed will permit the continuous tracking of active weapon sonars in the presence of interference from countermeasures and other sources. Existing submarine acoustic sensors will be used. Multiple emitter location techniq ...

    SBIR Phase I 1998 Department of DefenseNavy
  3. Corrosion Resistant Composite Launch Tube for Out Board Submarine System

    SBC: BELTRAN, INC.            Topic: N/A

    The project is dedicated to the development of a composite construction for the launch tube of an out board submarine system that would attain an extended service life of 10 years. This is a complex R&D project that includes: determination of design parameters of operational force-temperature-time conditions; selection of the appropriate structural and refractory coating materials; selection of a ...

    SBIR Phase I 1998 Department of DefenseNavy
  4. Superconducting tunable multipole bandpass filter with in-situ trim

    SBC: HYPRES, INC.            Topic: N/A

    In this Phase I SBIR project, HYPRES proposes to demonstrate a tunable lumped-element superconducting bandpass filter for transmit/receive isolation applications, using Josephson circuits for in situ trim and control. Such a filter will provide insertion loss below 1 dB and 60 dB out-of-band rejection in a filter which can be tuned over the range 500 MHz - 2 GHz. The project will take advantage o ...

    SBIR Phase I 1998 Department of DefenseNavy
  5. Advanced Fiber Optic Link Simulator

    SBC: RSOFT DESIGN GROUP            Topic: N/A

    In the continually advancing information age, the needs for rapid and high-performance data communications capabilities are increasing exponentially. The capabilities of strictly electronic communications technologies cannot keep pace with these rapidly increasing demands, and optoelectronics and fiber optics technologies have stepped in to meet the challenge. Fiber optics are now heavily used in ...

    SBIR Phase I 1998 Department of DefenseNavy
  6. Induction Carburizing--A Novel Cost Effective, Environmentally Safe, Affordable Technology

    SBC: SANOVA LLC            Topic: N/A

    Carburizing of steels to improve wear resistance is an old but widely used process. Current furnace technologies are expensive because their extensive requirements for time, space, labor, materials, energy and maintenance, and are harmful to the enviroment due to active atmosphere and heat losses. Separate equipment is needed to establish desired properties in the part case and core. The proposed ...

    SBIR Phase I 1998 Department of DefenseNavy
  7. Small, Rugged Internal Combustion Engine

    SBC: Veritay Technology, Inc.            Topic: N/A

    The Department of Defense has a growing interest in unmanned aerial vehicles (UAVs) to provide over-the-horizon surveillance, detection, classification and destruction of time-critical surface targets. Forward Area Support Munition (FASM), a Navy ATD program approved for FY99 start, is a 5-inch gun-launched projectile that transforms into a propeller propelled UAV. A future engine for the system ...

    SBIR Phase I 1998 Department of DefenseNavy
  8. Develop a Lightweight Electronic Equipment Enclosure

    SBC: Xc Associates, Inc.            Topic: N/A

    The Navy is imposing weight limits on the Cooperative Engagement (CeC) Program, the electronic equipment racks presently used by the Navy are very heavy and expensive to produce, this Program will develop a lightweight rack which will meet the operational requirements and be less expensive to product. Military systems are becoming increasingly complex and have to meet a larger arra of requirement ...

    SBIR Phase II 1998 Department of DefenseNavy
  9. TRANSPORTABLE RF SIMULATOR FOR ELECTRONIC SUPPORT MEASURE (ESM)

    SBC: AMHERST SYSTEMS, INC.            Topic: N/A

    THE PROPOSED STUDY WILL GENERATE PERFORMANCE AND DESIGN SPECIFICATIONS FOR AN RF SUBSYSTEM TO BE ADDED TO THE TRAINING AND MAINTENANCE SYSTEM (TRAMS). PRELIMINARY GUIDELINES FOR THE PROPOSED DESIGN EFFORTS ARE (A) AN INSTANTANEOUS EMITTER CAPACITY OF UP TO 150 EMITTERS (B) 2-18 GHZ FREQUENCY COVERAGE, AND (C) LIGHT WEIGHT AND PACKAGED FOR CARRY-ON EMPLOYMENT. THE PHASE I TASKS WILL REVIEW OVERALL ...

    SBIR Phase I 1989 Department of DefenseNavy
  10. INTEGRATED BATTLE FORCE SCENARIO GENERATION

    SBC: Applied Logic Systems, Inc.            Topic: N/A

    THE NAVY TODAY POSSESSES DATABASES SUPPORTING THE UNIQUE REQUIREMENTS OF INDIVIDUAL COMBAT TRAINING SYSTEMS. THESE INDIVIDUAL DATABASES ARE IMPLEMENTED USING DIFFERENT DATABASE MANAGEMENT SYSTEMS (DBMSS) AND SUPPORT DIFFERING PROGRAMMING LANGUAGES. MANY EXIST ON SEPARATE COMPUTER HARDWARE. TO GENERATE ACCURATE AND REALISTIC SCENARIOS FOR BATTLE FORCE TACTICAL TRAINING, IT IS NECESSARY TO ACCESS, C ...

    SBIR Phase I 1989 Department of DefenseNavy
US Flag An Official Website of the United States Government