You are here

Award Data

For best search results, use the search terms first and then apply the filters

The Award database is continually updated throughout the year. As a result, data for FY20 is not expected to be complete until September, 2021.

  1. Acoustic Intercept Receiver for Naval Special Warfare Undersea Vehicles

    SBC: Advanced Acoustic Concepts, Inc.            Topic: N09T012

    The current generation of high-frequency active 3-D acoustic imaging systems presents a challenge to the covert use of Underwater Vehicles (UVs) by Special Forces teams. An acoustic intercept capability is needed to detect active signals before the UV is detected, so that it can vector away from the source. The team of Advanced Acoustic Concepts and Montana State University propose to design and p ...

    STTR Phase I 2009 Department of DefenseNavy
  2. High Speed Compact Vaneaxial Fans


    We believe the following improvements are possible in vaneaxial fans: efficiency through improved fan blade design, coupled with the freedom to operate at speeds substantially higher than 3600rpm; reduced size by operating the fan at higher speed allows s

    SBIR Phase I 2009 Department of DefenseNavy
  3. High Temp Standoff Dielectric Antenna Windows Based on 3-D Woven Preforms

    SBC: 3TEX, Inc.            Topic: N08071

    Supersonic cruise missiles offer the ability to hit a time critical target with precision and lethality from long distances, yet the high speed generates temperatures on the exterior surfaces of the missile that can exceed the limitations of high temperature structural metals like titanium. Also, insulation to protect electronics equipment in the missile is required. One solution that demonstrates ...

    SBIR Phase II 2009 Department of DefenseNavy
  4. Collective Protection for Military Working Dogs

    SBC: AGAVE BIOSYSTEMS INC.            Topic: CBD08103

    Shelter enclosures for military working dogs in the event of a CB attack is a technology gap identified by the Joint Requirements Office. Important parameters to consider in the design of protective enclosures include low weight and size to minimize transport requirements; rapid setup; and accommodation of canine physiological and psychological comfort needs while providing protection against CB ...

    SBIR Phase II 2009 Department of DefenseOffice for Chemical and Biological Defense
  5. Closed-Loop Fabrication of Free-Form Optics

    SBC: APPLIED SCIENCE INNOVATIONS, INC            Topic: N07181

    To meet the need of the Navy in fabrication and measurement of conformal windows such as toroidal to precise optical tolerances from ceramic materials, Applied Science Innovations (ASI) proposes Phase II development of the Closed-Loop Fabrication of Free-Form Optics (CLF3O), building directly on ASI''s successful Phase I feasibility studies. The proposed CLF3O system is a modular attachment for in ...

    SBIR Phase II 2009 Department of DefenseNavy
  6. Metrology of Corrective Optics for Conformal Windows and Domes Using Scanning Low-Coherence Dual-Wavelength Interferometry

    SBC: ASE OPTICS            Topic: N08029

    As technology advances, there is increasing demand for higher quality optics with fewer aberrations. Aspheric optics meet these needs, but at present commercial systems to test such lenses are limited. This keeps the costs high and stifles the market. During Phase I of this project, ASE Optics has developed a non-contact metrology system capable of simultaneously measuring the internal and externa ...

    SBIR Phase II 2009 Department of DefenseNavy
  7. Robust Autonomous Maneuvering of Unmanned Air Systems in Challenging Environmental/Weather Conditions for Safety, Mission Effectiveness, and Endurance

    SBC: Atair Aerospace, Inc            Topic: N09T025

    The objective of this proposal is to develop and demonstrate methods of autonomous guidance and flight control that will permit safer and more effective operation of unmanned air systems under challenging weather conditions, and to exploit to the extent possible utilization of winds and other environmental conditions to increase mission effectiveness. Atair Aerospace has over the past 5 years dev ...

    STTR Phase I 2009 Department of DefenseNavy
  8. Media Free Coatings Removal Technology for Navy Platforms using Atmospheric Plasma

    SBC: Atmospheric Plasma Solutions, Inc.            Topic: N091065

    The Navy and other DoD components require a media-free, environmentally friendly, rapid, and non-destructive method to remove coatings applied on and aboard Navy ships. Atmospheric Plasma Solutions Inc. (APS) has developed an atmospheric plasma process to accomplish this goal. Current processes for the removal of coatings for shipboard applications are expensive, require massive amounts of energy, ...

    SBIR Phase I 2009 Department of DefenseNavy
  9. Composite-to-Metal Jointing Technology

    SBC: BELTRAN, INC.            Topic: N07T021

    Beltran proposes to continue the development of an advanced technology for joining of large composite and steel hull structures which are not prone to sudden failure and have much higher strain-to-failure ratio and increased energy absorption than conventional bonds. To ensure joints "structural efficiency, durability, producibility, reparability, and affordability, the Phase II STTR project will ...

    STTR Phase II 2009 Department of DefenseNavy
  10. Development of Optimizer for Noise Reduction for Military Airfields and Surrounding Areas

    SBC: Blue Ridge Research And Consulting, LLC            Topic: N091016

    Emerging new military high-performance aircraft and most current fighter aircraft generate community noise footprints that are in many cases 10 times or larger in size than current transport commercial aircraft. These higher levels lead to community annoyance, expensive and restrictive noise mitigation, and restriction of operations. Noise reduction technologies have been developed and employed on ...

    SBIR Phase I 2009 Department of DefenseNavy
US Flag An Official Website of the United States Government