You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY20 is not expected to be complete until September, 2021.

  1. Ethane/isotopic methane CRDS analyzer

    SBC: Entanglement Technologies, Inc.            Topic: 833D

    Entanglement Technologies, Inc. (ET) proposes to develop a gas analyzer for ethane and isotopologues of methane to study of methane sources and sinks, using cavity ring-down spectroscopy (CRDS). Methane is an important contributor to global climate change, and a participant in air pollutant reactions such as ozone. Understanding methane sources, sinks, and transport between them is crucial to pred ...

    SBIR Phase I 2016 Department of CommerceNational Oceanic and Atmospheric Administration
  2. Hybridized Additive Manufacturing for Medical Equipment (HAMME) technology

    SBC: Interlog Corporation            Topic: DLA152002

    To address the Defense Logistics Agency (DLA) needs for 3D printing technology for the medical supply chain, Interlog Corporation proposes to develop a new Hybridized Additive Manufacturing for Medical Equipment (HAMME) technology enabling to build multiple material equipment/supplies in a single platform. The HAMME is based on a unique, precision instantaneous energy generation mechanism providin ...

    SBIR Phase I 2016 Department of DefenseDefense Logistics Agency
  3. Reinforced Additively Manufactured Compression Assisted Molding (RAMCAM) of On-Demand Environmentally Stable Structural Composite Parts

    SBC: SAN DIEGO COMPOSITES, INC.            Topic: DLA152001

    San Diego Composites, Inc. (SDC) is developing the Reinforced Additively Manufactured Compression Assisted Molding (RAMCAM) pod to produce on-demand, corrosion resistant, aluminum and stainless steel equivalent parts in less than three days. RAMCAM combines the advantageous 2 day lead time of custom parts produced by 3D printing with the 1 day forging of structural parts via composite compression ...

    SBIR Phase II 2016 Department of DefenseDefense Logistics Agency
  4. L-Band Radio Frequency Interference Filtering

    SBC: ADAPTIVE DYNAMICS, INC.            Topic: 844

    In Phase 1, Adaptive Dynamics Inc. (ADI) propose to do a PHY layer MATLAB simulation and optimization of the 'IMPS' Wideband MAGIC® Interference Mitigation (IM) filter for NOAA. This will demonstrate the feasibility and performance of the IMPS Wideband MAGIC® IM filter algorithm in effectively identifying and separating out unwanted interference from the desired signal of interest (SOI), without ...

    SBIR Phase I 2016 Department of CommerceNational Oceanic and Atmospheric Administration
  5. Aircraft Alternative Braking System for Reduced Cost of Sustainment

    SBC: ENGINEERING AND SOFTWARE SYSTEM SOLUTIONS, INC            Topic: DLA161002

    Most fielded aircraft weapon systems currently utilize wheel/brake technology that was developed in the 1960s thru 1980s.The wheel/brake systems rely almost exclusively on friction brakes to convert kinetic energy during a landing or rejected takeoff into heat energy.These friction-based components require large investments in high cost spares to replace worn friction consumables. Furthermore, str ...

    SBIR Phase I 2016 Department of DefenseDefense Logistics Agency
US Flag An Official Website of the United States Government