Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until June, 2020.

  1. Reflex Triode

    SBC: KTECH CORP.            Topic: N/A

    "Reflex triode bremsstrahlung sources potentially provide warm X-ray sources (20 keV to 500 keV), capable of generating high doses (~10 cal/g gold) over exposure areas of ~20 cm2. This needed capability allows experimental verification of warm X-ray inducedthermomechanical response, SGEMP, and box IEMP models for achieving component and system certification to hostile environments.In a reflex trio ...

    SBIR Phase I 2002 Department of DefenseDefense Threat Reduction Agency
  2. Reflex Triode

    SBC: KTECH CORP.            Topic: N/A

    "Reflex triode bremsstrahlung sources potentially provide warm X-ray sources (20 keV to 500 keV), capable of generating high doses (~10 cal/g gold) over exposure areas of ~20 cm2. This needed capability allows experimental verification of warm X-ray inducedthermomechanical response, SGEMP, and box IEMP models for achieving component and system certification to hostile environments.In a reflex trio ...

    SBIR Phase II 2002 Department of DefenseDefense Threat Reduction Agency
  3. Diaphragm Pressure Gauge

    SBC: KTECH CORP.            Topic: N/A

    "Nuclear Weapons Effects Tests (NWET) frequently require that the test article be irradiated in an ultra-clean environment, making survivable shields a necessary part of many debris systems. Survivable shields as large as 12 inches in diameter are requiredbut have yet to be demonstrated in Plasma Radiating Source (PRS) environments. The loads on a survivable shield are a combination of radiation i ...

    SBIR Phase I 2002 Department of DefenseDefense Threat Reduction Agency
  4. Adiabatic Thermopile for Radiation Dosimetry

    SBC: KTECH CORP.            Topic: N/A

    "Measurements of fluence from a Plasma Radiation Source (PRS) are critical to the performance of accurate Nuclear Weapon Effects (NWE) experiments. Fast, total stopping calorimeters have been demonstrated to provide a robust, reusable, economic sensor forfluence measurements. However, the output of these sensors is a few millivolts and thus high signal to noise recording is difficult to achieve, ...

    SBIR Phase I 2002 Department of DefenseDefense Threat Reduction Agency
  5. Capillary discharge source for high fidelity, plasma radiation source loads

    SBC: KTECH CORP.            Topic: N/A

    Science based assessments of the response of systems and material to hostile nuclear environments require detailed verified material response and failure criteria for confident results. Consequently there is a need for the development of experimentaltechniques to measure low pressure equation of state parameters accurately and economically using radiation simulators. The development of a soft x- ...

    SBIR Phase I 2001 Department of DefenseDefense Threat Reduction Agency
  6. Large Area Survivable Shield Design

    SBC: KTECH CORP.            Topic: N/A

    The measurement of the variation of fluence from a Plasma Radiating Source (PRS) with polar angle is critical to the definition of the stimuli acting on an effects experiment using PRS diagnostics because in general experiments and diagnostics view thesource from different angles. The polar angle fluence distribution is controlled by the opacity of the pinch, which is a sensitive function of pinc ...

    SBIR Phase I 2001 Department of DefenseDefense Threat Reduction Agency
  7. Development of a Soft X-Ray Driven Flyer Plate System for Low Pressure Equation of State Studies

    SBC: KTECH CORP.            Topic: N/A

    Present reflex triode (RT) design performance is limited by debris shield response. The shield designs were derived empirically to satisfy specific experiment requirements. Optimizing the RT design will double target dose. Debris shield deformation definesthe closest permissible location of the test object and therefore determines the maximum dose achievable. The deformation of the debris shield c ...

    SBIR Phase I 2001 Department of DefenseDefense Threat Reduction Agency
  8. Reflex Triode Design Optimization

    SBC: KTECH CORP.            Topic: N/A

    Survivable shields are a necessary part of many soft x-ray debris mitigation systems that provide ultra clean test environments for nuclear weapons effects testing. Existing test requirements demand ultra large area survivable shields (12 inch diameter).Existing designs are limited to relatively small areas at low fluences and/or impose severe x-ray attenuation penalties. A methodology for the d ...

    SBIR Phase I 2001 Department of DefenseDefense Threat Reduction Agency
  9. Radiation Effects Modeling for High Yield, Reliable Integrated Circuits

    SBC: AET, Inc.            Topic: N/A

    The Defense Special Weapons Agency (DSWA) has identified a need to improve the radiation hardness of advanced integrated circuit technologies. To be practical, this must be achieved in a cost effective way. This proposal by AET, Inc. directly addresses these concerns. Specifi-cally, this proposal provides a means to achieve significant advance in radiation hardness of large scale integrated cir ...

    SBIR Phase I 1997 Department of DefenseDefense Threat Reduction Agency
  10. Nuclear Weapons Effects Phenomenology

    SBC: Applied Physics Technologies            Topic: N/A

    The nuclear weapons community has traditionally focused on the next generation or level of weapon capability complimented by gathering and analysis of actual test data. Now, with the cessation of actual weapons testing, there is an increased need to use the actual test data in modeling techniques to better understand the phenomenology and potential effects of nuclear weapons. The first phase of ...

    SBIR Phase I 1997 Department of DefenseDefense Threat Reduction Agency
US Flag An Official Website of the United States Government