Award Data

ColdQuanta, in partnership with Dr. Zoya Popovic at the University of Colorado at Boulder, proposes to develop a three-dimensional quantum-enhanced radio-frequency (RF) signal sensor and direction finder. Our approach combines Rydberg-atom-based RF electrometry and discrete lens arrays (DLAs) of planar antennas. The DLA will serve as a Fourier optic for an incident wave, and a Rydberg-atom RF elec ...

The ability to authenticate electronic devices is an important step towards modernizing the hardware/software of our Nations communication systems. Protecting these targeted networks and devices from malicious cyber-based attacks is becoming increasingly important as the technological and cyber capabilities of our adversaries continue to advance. In addition to network security, device authenticat ...

On-site activated decontaminants will revolutionize chemical and biological decon because the activated solution is produced on demand, without the limitations of traditional pre-made mixtures. TDAs system uses electrical activation to convert battery power into reactive chemicals that quickly destroy chemical and biological warfare agents. Prior to activation, the decontaminant mixture can be saf ...

A Battlefield Airman (BA) has one of the most challenging positions in the military. BA personnel are tasked with the dual roles of being warfighters as well as Combat Controllers, Pararescuemen, Tactical Air Control Party (TACP) members and Special Operations Weather Technicians often while behind enemy lines. These complex duties require high fidelity training. In some cases, such as Pararescuem ...

Scanning probe microscopy (SPM) is a technique used to detect near-field interaction when a sample is rater-scanned by a probe. Example include atomic force microscope (AFM) and scanning tunneling microscope (STM). It offers nanometric and atomic image resolution. In this field, an emerging technique, Near-Field Scanning Microwave Microscopy (SMM), utilizes microwave evanescent waves to attain the ...

Over the last decade the amount of data available from the internet, sensors and other sources has grown dramatically providing the opportunity to gain novel insights in many fields. Uncovering non-linear low dimensional structure in high-dimensional data (i.e., manifold learning), a key to summarization, remains a challenging problem which ultimately inhibits knowledge discovery. Intelligent Auto ...

Our nation’s warfighters require advanced armor to give them the best protection while allowing mobility to perform their missions. This proposal will develop two powerful tools to aid future body armor advancements. First, this research program will develop a statistical analysis software that will predict likelihood of impacts based on defined attack scenarios (i.e. rifle, distance and firing ...

The ability to predict the ignitibility potential of a combustor at various operating conditions is not practical at this time due to the complexity of this process. Ignition within a gas turbine combustor is dependent on various parameters; including spark (or plasma) energy, flow conditions, fuel/air ratio, and fuel spray density. All these parameters must be properly predicted in order to effec ...

In partnership with the Colorado School of Mines Alliance for the Development of Additive Processing Technologies and with support from the Johns Hopkins University Energetic Research Group, Special Aerospace Services will provide the Air Force with characterization of fully dense Selective Laser Melted GRCop-84 subjected to a variety of manipulations that affect key performance metrics for regene ...

The Candent Technologies “Reduced Cavitation, High Efficiency Outboard Propulsor for Small Planing Craft” Phase II program is structured to develop an advanced waterjet propulsor for the Combat Rubber Raiding Craft (CRRC). This new axial flow waterjet propulsion system is designed as a “bolt on” assembly that replaces the lower unit of the existing MFE 55 outboard motor. This new propulsio ...