You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY23 is not expected to be complete until September, 2024.

Download all SBIR.gov award data either with award abstracts (290MB) or without award abstracts (65MB). A data dictionary and additional information is located on the Data Resource Page. Files are refreshed monthly.

The SBIR.gov award data files now contain the required fields to calculate award timeliness for individual awards or for an agency or branch. Additional information on calculating award timeliness is available on the Data Resource Page.

  1. Modeling Leadership Dynamics in Multinational Environments

    SBC: MacroCognition, LLC            Topic: ST092002

    We propose to develop a computational model of leadership designed to capture complex variables including cultural differences in leadership requirements along with task differences, primarily ill-defined goals, which pose leadership challenges. Rather than avoiding these kinds of complexity and developing a computational model that is unlikely to scale up, we believe there is more to be gained b ...

    STTR Phase I 2010 Department of DefenseDefense Advanced Research Projects Agency
  2. Modeling and Optimizing Turbines for Unsteady Flow

    SBC: Florida Turbine Technologies Inc.            Topic: ST13A005

    Pressure gain combustion has the potential to significantly improve the specific fuel consumption for gas turbine engines by realizing a pressure rise through the combustor as opposed to a pressure drop. One drawback to this form of combustion is the cycl

    STTR Phase I 2013 Department of DefenseDefense Advanced Research Projects Agency
  3. Limit State Design of Composite Aerospace Structures

    SBC: CORNERSTONE RESEARCH GROUP INC            Topic: ST13A006

    Federal Aviation Administration Advisory Circular 20-107B provides guidance on the achievement of compliance with Title 14 of the Code of Federal Regulations regarding airworthiness type certification requirements for composite aircraft structures necessi

    STTR Phase I 2013 Department of DefenseDefense Advanced Research Projects Agency
  4. Novel Extensible Design Approaches for Advanced Aircraft Composite Structural Architectures (MSC P4135)

    SBC: MATERIALS SCIENCES LLC            Topic: ST13A006

    Among the factors that inhibit the use of composite materials in both general aviation aircraft and DoD platforms are the high cost of engineering and the cost of certification. Unless manufacturers can control risk when introducing new materials and pro

    STTR Phase I 2013 Department of DefenseDefense Advanced Research Projects Agency
  5. VOC Breath Analysis with Ultra-Sensitive Microwave Spectroscopy

    SBC: NOKOMIS INC            Topic: DHP16C002

    Nokomis proposes to develop a real-time microwave spectroscopy device to identify Volatile Organic Compounds (VOCs) associated with Pulmonary Oxygen Toxicity. Exhaled breath contains VOCs that act as signatures of bodily health, and are able to be utilized for health diagnostics. The proposed work will demonstrate sensitivity to the presence of chemicals at less than 50 ppb concentration levels, a ...

    STTR Phase I 2017 Department of DefenseDefense Health Agency
  6. Ultra-Wide Band RF Quantitative Diagnostics of Burn Injuries

    SBC: NOKOMIS INC            Topic: DHP16C005

    This proposal is dedicated to development of portable device for -on site- diagnostic of burn injury. The design will utilize a technology Ultra-Wide Band RF waves of ultra-low intensity (harmless by Federal Standards). The emitted RF waves will reflect from boundaries between tissues normal and damaged by injury to quantitatively characterize severity of burn and would require minimal skills fro ...

    STTR Phase I 2017 Department of DefenseDefense Health Agency
  7. Advanced Morphing Moulage for Medical Training (AMM-MT)

    SBC: VCOM3D INC            Topic: DHA17A002

    For this Phase I SBIR proposal, Vcom3D proposes to design advanced medical moulage that accurately simulates the progression of an injury or pathology by morphing through a series of clinical states to enable learners to confirm the progression of the wound and to determine whether iatrogenic errors or pathologies occurred duing treatment. The physical morphing moulage may be applied to medical m ...

    STTR Phase I 2017 Department of DefenseDefense Health Agency
  8. Dynamic virtual moulage based on thin film adhesive displays

    SBC: ARCHIE MD INC.            Topic: DHA17A002

    Providing Army combat medics with meaningful experience in treatment of battlefield injuries is a particular challenge. Moulage has the potential to assist in acquiring what could otherwise be very hard-to-come-by preparatory experience for the distressing real-life emergencies medics and soldiers may encounter in the field. However, current approaches to moulage are limited in their ability to re ...

    STTR Phase I 2017 Department of DefenseDefense Health Agency
  9. Principled Design of an Augmented Reality Trainer for Medics

    SBC: UNVEIL LLC            Topic: DHA17A003

    Recent advances in augmented reality (AR) offer valuable opportunities for simulationbased training outside of a medical simulator facility. The potential benefits for combat casualty care training are particularly powerful, as over 100,000 U.S. military medical personnel must be prepared to quickly respond to a broad range of injuries at any point in time. We propose to develop and evaluate a hig ...

    STTR Phase I 2017 Department of DefenseDefense Health Agency
  10. Interactive Mixed Media Education augmented Reality Simulation Engine (IMMERSE)

    SBC: CHI SYSTEMS INC            Topic: DHA17A003

    CHI Systems, in partnership with the Virginia Serious Games Institute, proposes to design, develop, and assess the Interactive Mixed Media augmented Reality Simulation Engine (IMMERSE) technology, a compelling and instructionally rich training experience using augmented and mixed-reality for TC3 trainees, and then evaluate the impact of the IMMERSE approach on trainee understanding and training ef ...

    STTR Phase I 2017 Department of DefenseDefense Health Agency
US Flag An Official Website of the United States Government