You are here

Award Data

For best search results, use the search terms first and then apply the filters

The Award database is continually updated throughout the year. As a result, data for FY20 is not expected to be complete until September, 2021.

  1. Titanium-Composite Body Armor Plates

    SBC: Advanced Protection Products,            Topic: N/A

    Advanced Protection Products, Inc. (APPI) will use advanced materials and processes to develop and certify Very Light Body Armor (VLBA) plates that are capable of defeating a variety of ballistic threats. The VLBA plates will be designed using a titanium allow based metallic-composite armor system to provide cost-effective, lightweight protection. Composite facing and backing materials will be u ...

    SBIR Phase I 1998 Department of DefenseSpecial Operations Command
  2. Dynamic Firing Zone Imaging System

    SBC: Conceptual Systems & Software Inc            Topic: N/A

    An automated dynamic firing zone generation imaging system is needed to increase the effectiveness and utility of shipboard weapon systems. The current manual firing zone definition process is manpower intensive, complex, and cannot account for motion or changing topside configuration. These limitations greatly restrict the lethality and utility of shipboard weapons. This project proposes a dyna ...

    SBIR Phase I 1998 Department of DefenseNavy
  3. Unified HP/RT Development to Deployment Middleware Platform

    SBC: Conceptual Systems & Software Inc            Topic: N/A

    A significant problem for modern combat control system implementations is the incompatible development and deployment environments. These applications have specific performance requirements that until recently were only accurately obtained on the target installation system. However, for various logistic and economic reasons, the platforms utilized for advanced applications have typically been inc ...

    SBIR Phase I 1998 Department of DefenseNavy
  4. TERFENOL-D Lamination Process Cost Reduction

    SBC: Etrema Products, Inc.            Topic: N/A

    All high performance TERFENOL-D sonar devices require the drivers to be laminated for eddy current control. The process of laminating TERFENOL-D to present interlamina resistivity requirements results in low yields due to considerable material loss and is, therefore, a wasteful process. The objective of this program is to define and experimentally verify accurate interlamina resistivity levels f ...

    SBIR Phase I 1998 Department of DefenseNavy
  5. Virtual Vertical Aircraft Signal Trainer

    SBC: FATS, INC.            Topic: N/A

    AeroMed Software, L.L.C., proposes to develop an interactive virtual environment simulator for vertical aircraft signal training. The proposed system is intended to provide Landing Signal Enlisted (LSE) trainees with a dynamic training device similar to the operational flight trainers used by aviators. Recent advances in data acquisition, signal processing and graphics software, computer process ...

    SBIR Phase II 1998 Department of DefenseNavy
  6. Raman Image Amplifier for Marine LIDAR Applications

    SBC: LITE CYCLES, INC.            Topic: N/A

    This project will focus on the development of a compact, rugged, low-maintenance, cost-effective, all solid-state Marine Raman Image Amplifier (MARIA) capable of amplifying low-level ocean LIDAR images and producing gated images with potential gate times of tens of picoseconds. The innovative technology to be implemented is based on a solid-state stimulated Raman scattering technique developed by ...

    SBIR Phase I 1998 Department of DefenseNavy
  7. A Novel Processing Technique for the Large-Scale Production of Red Phosphorus

    SBC: ATS-MER, LLC            Topic: N/A

    Current techniques for the production of red phosphorus powders cannot produce 5¿m size powders while maintaining a pure surface. Two new processing techniques are suggested that are capable of processing red phosphorus into powders 5¿m or smaller in size. These techniques have been demonstrated with conventional metals and alloys but not with phosphorus. One important advantage of these proc ...

    SBIR Phase I 1998 Department of DefenseNavy
  8. Low-Cost Hot-Gas-Turbine Powered Hydraulic Power Supply

    SBC: M-DOT Aerospace            Topic: N/A

    M-DOT Inc. proposes to conduct a trade study and design a low- cost hot-gas turbine driven fuel pump/hydraulic power supply for use on an advanced missile system. When design is complete, a cost analysis of a proposed production version will be conducted. The unit will be capable of the following: Delivering 0.5 lbm/sec of jet fuel against a back pressure of 100 psia and providing 1 hp of hydraul ...

    SBIR Phase II 1998 Department of DefenseNavy
  9. Thin Film Thermoelectric Devices

    SBC: Nanomaterials Research LLC            Topic: N/A

    Thin film thermoelectric (TE) technology offers the potential for low cost, low weight, small volume and high efficiency heating and cooling systems for many applications. More importantly, the recent research has indicated the possibility of drastically improving TE performance (ZT) of TE materials by using superlattice engineering, which can only be realized through the thin film TE technolo ...

    SBIR Phase II 1998 Department of DefenseNavy
  10. Automatic Test System (ATS) Analysis and Configuration Management Tool

    SBC: QUINCY STREET CORP.            Topic: N/A

    The overall objective of this project is to develop an easy to use, reliable toolset to match test requirements to test equipment. The matching criteria will be developed by utilizing ABBET test foundation framework concepts. The requirements and capabilities for the test process and equipment wlll be defined in terms of signals. In the case of test equipment, additional information concerning ...

    SBIR Phase I 1998 Department of DefenseNavy
US Flag An Official Website of the United States Government