Award Data

A pressing challenge in automotive, aerospace, and other manufacturing industry is the ability to measure the mechanical properties of formed metal and alloy components on a part-by-part basis. We propose to develop a non-destructive testing system suitable for rapid on-line measurement of critical mechanical properties of steel parts as they are being produced. Our approach is based on measuremen ...

Mayur Tech demonstrated a prototype web based system for submitting and storing observational station metadata for NOAA NWS programs during phase 1. We propose to develop this prototype into a complete metadata operational system leading to the development of commercial tools in phase 2. Mayur Tech plans to enhance the current CSSA metadata system, and add new functionality to NWS and FAA sites. T ...

Mayur Tech demonstrated a prototype web based system for submitting and storing observational station metadata for NOAA NWS programs during phase 1. We propose to develop this prototype into a complete metadata operational system leading to the development of commercial tools in phase 2. Mayur Tech plans to enhance the current CSSA metadata system, and add new functionality to NWS and FAA sites. T ...

Utilizing new hard, etch resistant photoresists derived from epoxy formulations such as SU-8 to serve as the mold for electroless metaldeposition for MEMS electroforming techniques, a fully micro-miniaturized cross capacitor can be realized. A Micro-Electroformed Cross Capacitor (MECC) is built by electroforming high aspect metals atop the substrate. A Phase 1 effort would model MECC performance, ...

An inexpensive aerosol lidar is proposed by combining inexpensive fiber coupled diode laser and photon counting detection technology for air quality monitoring in metropolitan area. The combination of inexpensive light source and high sensitivity photon detection technology developed in the "Micro Pulse Lidar" project will result in a rugged and affordable lidar system for air pollution monitori ...

This Phase I SBIR research project will investigate the feasibility of an ammonia sensor based on an antimonide laser and an advanced, low noise modulation spectroscopy method. The rapid response and high sensitivity will allow the use of the eddy correlation method to provide continuous measurement of ammonia flux. Minor adjustments to the laser operating point will allow the instrument to measur ...

The ability to perform in-situ measurements of oxygen concentration in fire environments at a fast rate (better than 1 sec ) is not fulfilled by available sensor systems in the marketplace. Current systems involve extraction of gas samples with the required removal of water, particulate, and interfering chemical species, which can take several seconds to complete, prior to passing the samples to a ...

Reuse in software engineering is an exciting concept that has yet to be reliably implemented. The number of program subroutines that are truly generic (and therefore applicable across all applications) is limited. However, there are specific applications that are required by many organizations, albeit with a set of constraints specific to each organization. This project proposes to design a too ...

We propose to develop DIALOG, an environment for collaborative decision making that will enable health care providers and administrators to model, learn, and reason about their business enterprise. DIALOG will utilize a user-friendly, pen- and gesture-based graphical interface, and will enable "any time/any place" collaboration over shared digital libraries and dynamic "microworld" simulations. ...

It is proposed to develop a miniature guarded hot plate apparatus that can be used to determine the thermal conductivity or thermal resistance of very small specimens (1 to 3 cm square) of thermal insulation materials over a temperature range from at least -40 degrees Celsius to +65 degrees Celsius, with the apparatus having the capability to carry out measurements under controlled environments of ...