Award Data

"HgCdTe is the material of choice for high performance infrared red focal plane arrays (IRFPA) used in militarys night vision systems. One of the major problems IRFPA manufacturers face is the ineffective passivation of the highly reticulated HgCdTe detector surfaces, which results in poor performance. Furthermore, newly evolved FPA technology requires the creation of much challenging high-aspect ...

Approximately 5-6% of military injuries involve some form of major peripheral nerve injury that has little chance of spontaneous healing. Currently these injuries lead to major impairment of voluntary muscle function in the limbs and extremities, making tasks of walking, reaching, grasping, etc. very difficult or impossible for many patients. Focusing therapeutic treatments to segmental nerve in ...

We propose to develop a compact, integrated ion trap quantum system for quantum sensor, timekeeping, and processing applications. To do so, we leverage ColdQuantas expertise in miniature ultra-high vacuum (UHV) and atom chip technology and Duke Universitys expertise in microfabricated surface ion traps and quantum information processing experiments. We will produce designs and implementation pla ...

As the warfighter is increasingly using more highly integrated instruments, e.g. a laser rangefinder (LRF) combined with a laser designator and an imager, the need to decrease the size of these components becomes more important. Compact small munition applications of rangefinders particularly place an emphasis on size of the optical front end. In order to make the transceiver more compact, speci ...

A critical step in the extraction of elements from ore, especially rare earth elements that are found in complex minerals, is separation. Froth flotation is a highly versatile method for physically separating particles based on differences in the ability of air bubbles to selectively adhere to specific mineral surfaces in a mineral/water slurry. The particles with attached air bubbles are then ca ...

Physical Sciences Inc. in cooperation with Colorado State University proposes to develop a compact infrared flash 3D imaging sensor employing compressive sensing (CS) concepts. The CS 3D sensor offers a combination of high range resolution (cm), high point cloud density (100100 format), and fast 3D image frame rates (30 Hz) in a low cost, compact form factor employing commercial off the shelf comp ...

This proposal addresses the problem of PCSS/laser trigger integration using a single monolithic laser diode array, thus simplifying the entire optical delivery network necessary for efficient operation of PCSSs. The proposal constitutes a logical continuation of Phase I effort where the main focus was on the detailed design of the PCSS/laser diode array (LDA) integrated architecture. In Phase II ...

To achieve the goals of this program improving spectral coverage and output power of monolithic QCL sources - we propose to develop in collaboration with MIT Lincoln Laboratory a broadly tunable high power source that is based on Eos proprietary QCL array technology. The current generation of Eos commercially available fully packaged QCLAs (The Matchbox) can be tuned over a wavelength range of u ...

Thin-film, lightweight, large-area flexible inorganic solar cells have shown promise to meet the militarys remote power needs on the battlefield. However, thin film solar cells normally have inferior conversion efficiencies due to limited absorption of sunlight by the thin active layer. Various approaches have been investigated to improve conversion efficiencies of thin film solar cells. Among the ...

Friction stir additive manufacturing (FSAM) will be utilized for repair, fabrication and processing of Titanium components and sub-assemblies for high performance military applications. The innovation will address the issue of part distortion resulting from high residual stresses imposed during traditional fusion welding based additive manufacturing techniques. In addition to enhancing dimensional ...