Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until June, 2020.

  1. Development of UltrastableTi:sapphire Lasers for Optical Clock and Spectroscopy Applications

    SBC: Kapteyn-Murnane Laboratories, Inc.            Topic: N/A

    This Small Business Innovation Research Phase 1 project proposes to develop a femtosecond laser system optimized for optical clocks and other precision metrology applications. In principle, atomic optical transitions have the potential to provide radically higher-accuracy timekeeping, because of the very high frequency of an optical transition. The problem of counting, or down-counting, the oscill ...

    SBIR Phase I 2003 Department of CommerceNational Institute of Standards and Technology
  2. Monolithic Semiconductor Light Source with Spectral Controllability

    SBC: AHURA CORPORATION, INC.            Topic: N/A

    Solid-state light sources promise many advantages over traditional technologies. Among these advantages is the ability to construct a source whose relative spectral distribution can be tuned to better match a desired spectrum. We propose addressing this technical and market opportunity through the development of a novel single-chip semiconductor device which delivers high optical output power (>20 ...

    SBIR Phase I 2003 Department of CommerceNational Institute of Standards and Technology
  3. Standards Based Test Cases and Tools for CAE

    SBC: Softinway, Inc.            Topic: N/A

    A new generation of STEP is now coming on line with interfaces between CAD and CAE systems defined by AP 209. The goal of this proposal is to accelerate the deployment of a capability to exchange data between CAD and CAE systems by developing practical test cases for AP 209, as well as developing a software system tools to make the software deployment pilot programs practical. It is proposed to bu ...

    SBIR Phase I 2003 Department of CommerceNational Institute of Standards and Technology
  4. A Photon Counting Fiber Optic Scintillator Dosimeter

    SBC: Boston Science            Topic: N/A

    A Photon Counting Fiber Optic Scintillator Dosimeter will be constructed to extend the range of useful measurements around low energy photon sources. A micromachined plastic scintillator will be bonded to the end of a fiber optic cable. A photon counting detector package will be constructed to receive the light from the scintillator and record the count rate. Neutral density filters will be employ ...

    SBIR Phase I 2003 Department of CommerceNational Institute of Standards and Technology
  5. Direct-Digital Phase & Amplitude Noise Measurement System

    SBC: TIMING SOLUTIONS            Topic: N/A

    We propose to compare alternative architectures for phase noise measurement by directly sampling the RF waveform. Out of band modulation and cross correlation will reduce noise. The capabilities of each architecture will be determined using analysis and simulation. The results will be used to determine the feasibility of developing a commercially useful measurement instrument. If the results are p ...

    SBIR Phase I 2003 Department of CommerceNational Institute of Standards and Technology
  6. AutoCAS: Automated Communications Analysis System for use in Military Synthetic Environment Exercises

    SBC: Aptima, Inc.            Topic: N/A

    Effective communications are essential in military operations in urban terrain (MOUT). Leaders must coordinate distributed squads of soldiers in hostile, urban battlegrounds through communication. However, though verbal communications are easy to capture,it traditionally takes days or weeks to analyze and assess this valuable data. Thus, communications analysis has become the province of research ...

    SBIR Phase I 2003 Department of DefenseOffice of the Secretary of Defense
US Flag An Official Website of the United States Government