You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY23 is not expected to be complete until September, 2024.

Download all SBIR.gov award data either with award abstracts (290MB) or without award abstracts (65MB). A data dictionary and additional information is located on the Data Resource Page. Files are refreshed monthly.

The SBIR.gov award data files now contain the required fields to calculate award timeliness for individual awards or for an agency or branch. Additional information on calculating award timeliness is available on the Data Resource Page.

  1. Defect Free, Ultra-Rapid Thinning/Polishing of Diamond Crystal Radiator Targets (20??m) for Highly Linearly Polarized Photon Beams

    SBC: Sinmat Inc            Topic: 46e

    The fabrication of high-quality ultra thin (~20 micron) diamond crystals targets for 9 GeV highly polarized photon beams is an outstanding challenge. Current state of the art polishing/thinning techniques are not successful in thinning single crystal diamond to such dimension because of its extreme hardness and chemical inertness. These techniques create significant stresses surface and sub-surfac ...

    STTR Phase I 2010 Department of Energy
  2. Membrane Materials with Improved Properties

    SBC: UES INC            Topic: 10a

    Currently the commercially available technologies for H2 separation such as pressure swing adsorption and cryogenic distillation are very energy intensive. Membrane technologies can be very energy efficient; but for high selective membranes low flux and high cost are the major challenges that frustrate commercialization. Recently, cermet has shown promise because of less precious metal usage and m ...

    STTR Phase I 2010 Department of Energy
  3. High Temperature Unique Low Thermal Conductivity Thermal Barrier Coating (TBC) Architectures

    SBC: UES INC            Topic: 27c

    Higher operating temperature for the gas turbine engine is needed for enhanced efficiency, lower emission and increased performance goal. The current state-of-the-art thermal barrier coatings (TBCs) are not adequate to provide the needed protection for the metallic components of the turbine engine operating at higher TBC surface temperature (>1300

    STTR Phase I 2010 Department of Energy
  4. Recovery Act- Web-Based Diagnostic Tools for Online Monitoring of Photovoltaic Systems

    SBC: Wattminder            Topic: 07c

    Despite significant advancement in PV technology and efficiency, qualification testing and market penetration, actual performance in the field of operation under a myriad of environemental constraints remains an important topic. PV arrays are subject to degradation mechanisms that can significantly impact power production capability. For revenue-critical PV arrays, detection of underperformance an ...

    STTR Phase II 2010 Department of Energy
  5. Recovery Act- Performance Monitoring and Actionable Alert Messaging for Building Integrated Photovoltaics

    SBC: Wattminder            Topic: 07c

    Building Integrated Photovoltaics (BIPV) systems present significant challenges with respect to optimal energy efficiency of Photovoltaic (PV) arrays. In these systems, the PV panels replace roof tops, and other building components such as windows. Due to their diverse locations and orientations, influence of numerous environmental factors can significantly reduce the performance and overall eff ...

    STTR Phase I 2010 Department of Energy
  6. Accelerating Metagenomics Using Graphics Processing Units

    SBC: Multicoreware, Inc.            Topic: 35a

    A key application of the technological breakthrough associated with decreased cost of DNA sequencing is metagenomics. Metagenomics is the process of sequencing DNA from whole ecosystems, rather than individuals or cultures. This approach has the potential to allow the dissection of microbial ecosystems in biofuel producing agricultural land, toxic contaminated sites and hydrocarbon recovery enviro ...

    STTR Phase I 2010 Department of Energy
  7. Verification of CO2 Storage in Coal Beds

    SBC: Algorithmica Llc            Topic: 24b

    The injection and storage of captured CO2 in coal beds has been suggested as a strategy to reduce industrial emissions of CO2 into the atmosphere. The sequestration process involves the adsorption by coal of injected CO2 and an associated desorption of CH4 whose production can partially offset the operational cost. The acceptance of this strategy depends on: the ability to effectively monitor the ...

    STTR Phase I 2010 Department of Energy
  8. Recovery Act- High-Efficiency Membrane Regenerator for Liquid Desiccant Air Conditioning

    SBC: PAX SCIENTIFIC INC            Topic: 01a

    Low-Flow Liquid Desiccant Air Conditioning (LDAC) has the potential to dramatically lower the electricity used for commercial air conditioning by directly removing moisture from the air prior to cooling. But in order to achieve widespread market adoption, the mechanisms by which the liquid desiccant is regenerated must be made more energy efficient, reliable and cost-effective. Membrane technolo ...

    STTR Phase I 2010 Department of Energy
  9. Realization of Mulitlayer High Temperature Capacitors with New Dielectric Materials and Novel Thermal Spray Deposition Route

    SBC: DRS RESEARCH            Topic: 01a

    The main focus of this STTR is to design, develop, and evaluate high temperature capacitors using novel thermal spray coating processes, which will allow the devices to meet the performance requirements. Multilayer coating architecture will be adopted and the electrodes and dielectric material selections will be screened in Phase I to note material compatibility and high temperature performance. ...

    STTR Phase I 2013 Department of Energy
  10. Novel Module Architecture Development for Increased Reliability and Reduced Costs

    SBC: Creative Light Source, Inc            Topic: 07a

    Statement of Problem: The US DOE has set a goal to advance photovoltaics (PV) technology to reach installed costs of less than $1/Watt. This requires module costs below $0.50/ Watt. Thin film PV provides the lowest documented production cost per watt ($0.67) of any PV technology. Module reliability has a direct impact on the levalized cost of energy (LCOE), or the cost of the energy produced by ...

    STTR Phase I 2013 Department of Energy
US Flag An Official Website of the United States Government