Award Data

A unique type of air lubricated thrust bearing called a Wave Bearing is proposed to assist a rolling element bearing to carry the thrust load and to improve the bearing’s life when used in a micro gas turbine engine. The Wave Bearing technology will provide improved reliability, safety and life compared to rolling element bearings used alone, as well as to allow simplification of engine design a ...

Two-dimensional (2D) visualization techniques have limit capacity to achieve understanding of full dimensionality of the battlefield. Rewritable 3D holographic storage is promising for updatable 3D display applications. In Phase I, New Span Opto-Technology has demonstrated novel concepts of both holographic recording technique and recording material system without the use of high voltage. We have ...

Coal is an abundant source of energy in the USA, but is not currently utilized effectively. Recently, the DOE has begun a carbon sequestration program is to develop advanced CO2 capture and compression technology for existing coal-fired plants with increased efficiency with no more than a 35% increase in the cost of electricity. This will require new approaches and technologies to be successful. N ...

An eye-safe optically pumped laser based on a gas-filled hollow optical fiber will be demonstrated to lase at both near infrared (IR) and mid IR wavelengths. These lasers will be the first in a new class of IR lasers, based on the combination of hollow-f

While there are established methods available in determining the fatigue life of critical rotating components, there is still room for improvement for better understanding and prediction of life limiting factors. Improved risk assessment of jet engine disk components would require probabilistic modeling capability of the evolution of microstructural features, residual stresses and material anomali ...

Jet engine disk components are increasingly subjected to higher operating temperatures. To meet the demands of increasing thrust and higher operating temperatures, a newer generation of nickel based superalloys such as LSHR, Alloy 10, Rene104 and RR1000 are being processed with dual microstructure distributions. Fine grain, high strength, fatigue resistant bore properties are contrasted with co ...

Gallium Nitride (GaN) substrates are ideal materials for fabrication of high-power and high-frequency devices based on III-V materials. The current state-of-the-art Chemical Mechanical Polishing (CMP) methods are plagued by several challenges, including, surface charge affects due to surface contamination, and sub-surface damages, which can limit the quality of III-V devices. Furthermore, there is ...

Solid state lighting is being promoted as the ultimate lamps of future. Though the internal quantum efficiency of OLED devices is almost 100%, external efficiency is a mere 36% mainly because of poor light out-coupling (~40%) from the device. Improvement in light out-coupling to >70% and further reducing the manufacturing cost will rapidly accelerate the commercialization of the OLED technology. T ...

The fabrication of high-quality ultra thin (~20 micron) diamond crystals targets for 9 GeV highly polarized photon beams is an outstanding challenge. Current state of the art polishing/thinning techniques are not successful in thinning single crystal diamond to such dimension because of its extreme hardness and chemical inertness. These techniques create significant stresses surface and sub-surfac ...

Providing a reliable, clean and economical energy source is a priority of the US government. The challenge is to use coal, a secured and economical energy source, to produce clean hydrogen fuel to support domestic and global green economy with near-zero emission. Conventional separation technology and even developmental technology do not satisfy all of the requirements for hydrogen production from ...