List

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until April, 2020.

  1. Small, Heavy Fuel, Compression Ignition Small UAV Engines

    SBC: GSE, Inc.            Topic: SB022050

    This Heavy Fuel Engine (HFE) proposal describes an innovative propulsion system that meets the near term Army FCS class II OAV propulsion system requirements. The proposed approach is an innovative Supercharged Injected 60 degree V-twin uniflow four-cycle design of 450cc cylinder capacity designated (SIV-2225). Unlike commercial off the shelf conversions, the proposed SIV-2225 overcomes small scal ...

    SBIR Phase II 2004 Department of DefenseDefense Advanced Research Projects Agency
  2. N/A

    SBC: HIGH PERFORMANCE MATERIALS GROUP, LLC            Topic: N/A

    N/A

    SBIR Phase I 2000 Department of DefenseSpecial Operations Command
  3. A Trans-Atmospheric Turbojet Engine

    SBC: Hmx, Inc.            Topic: N/A

    A novel turbojet based propulsion system is described that is capable of continuous operation from takeoff to orbital insertion. This engine concept utilizes a conventional turbojet as its core with a dual function inlet that can accommodate bothatmospheric air and cryogenic liquid oxidizer. By varying the percentage of liquid oxidizer injected, the engine can operate either in turbojet mode, roc ...

    SBIR Phase I 2001 Department of DefenseDefense Advanced Research Projects Agency
  4. A Trans-Atmospheric Turbojet Engine

    SBC: Hmx, Inc.            Topic: N/A

    "Mass Injection Pre-Compressor Cooling (MIPCC) is a promising technology which can permit convention jet engines, normally limited in speed and altitude, to propel aircraft to substantially higher altitudes and velocities. By injecting coolant ahead of thecompressor and using its heat of vaporization to cool inlet gasses, the engine can operate at substantially higher velocities without exceeding ...

    SBIR Phase II 2002 Department of DefenseDefense Advanced Research Projects Agency
  5. FAILURE INVESTIGATION OF CERAMIC ARMOR BACKED BY ALUMINUM OR ALUMINUM MATRIX COMPOSITE SUPPORT-PLATES

    SBC: Lanxide Corporation            Topic: N/A

    IT IS PROPOSED THAT THE BALLISTIC PERFORMANCE OF TIB2 CERMAIC ARMOR TILES BACKED UP BY A VARIETY OF LIGHTWEIGHT SUPPORT-PLATES BE INVESTIGATED BY 1MEV FLASH X-RAY EQUIPMENT DURING PENETRATION, AND BY MACROSCOPIC AND MICROSCOPIC OBSERVATIONS OF RECOVERED TARGETS. THE SUPPORT-PLATE TEST MATRIX INCLUDES TWO MATERIALS (A STRUCTURAL ALUMINUM ALLOY AND A CERAMIC REINFORCED ALUMINUM MATRIX COMPOSITE), TW ...

    SBIR Phase I 1991 Department of DefenseDefense Advanced Research Projects Agency
  6. INVESTIGATION OF STRESS WAVES AND FAILURE PHENOMENOLOGY IN ALUMINUM METAL MATRIX COMPOSITE AND TIB2 LAMINATED ARMOR

    SBC: Lanxide Corporation            Topic: N/A

    TO UNDERSTAND BETTER HOW LAMINATED CERAMIC ARMOR PERFORMS, IT IS PROPOSED TO INVESTIGATE THE EFFECT OF THE IMPEDANCE MISMATCH AND INTERLAYER BOND STRENGTH (BETWEEN AI(2)0(3) REINFORCED ALUMINUM MATRIX COMPOSITES AND TIB(2)) ON STRESS WAVE PROPAGATION AND PENETRATION PHENOMENOLOGY DUE TO LONG ROD IMPACT. LANXIDE'S UNIQUE PROCESSING TECHNOLOGIES WILL BE USED TO FORM A STRONG METALLURGICAL BOND AT TH ...

    SBIR Phase I 1991 Department of DefenseDefense Advanced Research Projects Agency
  7. NOVEL CERAMIC/METAL COMPOSITES FOR ARMOR APPLICATIONS

    SBC: Lanxide Corporation            Topic: N/A

    CERAMICS HAVE BEEN SHOWN TO BE VERY EFFECTIVE IN THE DEFEAT OF A WIDE RANGE OF KINETIC ENERGY (KE) THREATS. HOWEVER, THE USE OF CERAMICS IN ARMORED VEHICLES HAS BEEN LIMITED DUE IN MOST PART TO THEIR HIGH COST. CERAMIC PARTICULATE REINFORCED METAL MATRIX COMPOSITES (MMCS) PRODUCED BY PRESSURELESS LIQUID METAL INFILTRATION ARE INEXPENSIVE RELATIVE TO MONOLITHIC CERAMICS DUE TO THE LOWER COST OF THE ...

    SBIR Phase II 1993 Department of DefenseDefense Advanced Research Projects Agency
  8. NOVEL CERAMIC/METAL COMPOSITES FOR ARMOR APPLICATIONS

    SBC: Lanxide Corporation            Topic: N/A

    N/A

    SBIR Phase I 1991 Department of DefenseDefense Advanced Research Projects Agency
  9. Chemical and Explosive Vapor Detection in Shipping Containers with Remotely Accessed Microcantilever Array Sensors

    SBC: Nevada Nanotech Systems Inc.            Topic: SB041005

    The remarkable sensitivity, compactness, low cost, low power-consumption, scalability, and versatility of microcantilever sensors make this technology possibly the best solution for container screening. In Phase I, Nevada Nanotech Systems (NNTS) successfully demonstrated all components of a prototype sensor system for measuring the concentrations of unlawful or hazardous materials in shipping con ...

    SBIR Phase II 2006 Department of DefenseDefense Advanced Research Projects Agency
  10. Chemical and Explosive Vapor Detection in Shipping Containers with Remotely Accessed Microcantilever Array Sensors

    SBC: Nevada Nanotech Systems Inc.            Topic: SB041005

    We present a highly qualified team, including security experts and technical experts, and a patent-pending new microcantilever array sensor technology (which has been tested for chemical and explosive detection) to be integrated with low-cost electronics and networking modules and implemented as an inexpensive and easily deployable solution to the shipping container inspection problem. Becau ...

    SBIR Phase I 2004 Department of DefenseDefense Advanced Research Projects Agency

Agency Micro-sites

SBA logo
Department of Agriculture logo
Department of Commerce logo
Department of Defense logo
Department of Education logo
Department of Energy logo
Department of Health and Human Services logo
Department of Homeland Security logo
Department of Transportation logo
Environmental Protection Agency logo
National Aeronautics and Space Administration logo
National Science Foundation logo
US Flag An Official Website of the United States Government