Award Data

If aquaculture is to become an increasing contributor to the food supply, it is critical that aquaculture feeds become less reliant on marine-derived fishmeal and fish oil as the preferred source of essential proteins and lipids. Not only is the wild fishery from which these products are extracted at maximum sustainable levels of harvest, but also there is increasing concern that these feedstocks ...

If aquaculture is to become an increasing contributor to the food supply, it is critical that aquaculture feeds become less reliant on marine-derived fishmeal and fish oil as the preferred source of essential proteins and lipids. Not only is the wild fishery from which these products are extracted at maximum sustainable levels of harvest, but also there is increasing concern that these feedstocks ...

The aquaculture industry currently consumes 70 percent of the global production of fish oil and 35 percent of total fishmeal. The salmon and trout fish farming sectors alone consume over one half of the world¿s fish oil. And if fish farming continues to grow at the current rate, then by 2010 the aquaculture industry could well be using all of the world¿s fish oil and half of its fishmeal. The ...

The objective of this project is to develop and validate improved methodology for the substantiation and the usage-based tracking of rotorcraft dynamic system components. A Helicopter Information Retrieval & Substantiation System(HIRSS) is proposed whichconsists of (1) an Universal Damage Tracking Algorithm(TM) capable of accommodating the different fatigue analysis methodologies of the manufactu ...

The objective of the Phase II research is to utilize the lessons learned from the Phase I risk reduction work to develop a prototype CAD-programmable environment for the development of condition-based maintenance systems for rotorcraft. This developmentenvironment features a CAD scenario modeler for constructing, via click n' drag modeling, fault-to-failure damage models which can account for the ...

The objective of the Phase II research is to utilize the lessons learned from the Phase I risk reduction work to develop a prototype CAD-programmable environment for the development of condition-based maintenance systems for rotorcraft. This developmentenvironment features a CAD scenario modeler for constructing, via click n' drag modeling, fault-to-failure damage models which can account for the ...

Reuse in software engineering is an exciting concept that has yet to be reliably implemented. The number of program subroutines that are truly generic (and therefore applicable across all applications) is limited. However, there are specific applications that are required by many organizations, albeit with a set of constraints specific to each organization. This project proposes to design a too ...

This NIST Phase 1 SBIR effort will demonstrate the feasibility of low noise single photon up conversion using KTiOPO4 (KTP) or LiNbO3 (LN) or Stoichiometric LiTaO3 (SLT) periodically poled waveguides and an 1800nm pump for a high efficiency single photon detector. The key innovation is using low noise periodically poled waveguides with a long wavelength (1800nm) pump leading to higher efficiency s ...

This SBIR Phase I effort will establish the feasibility of fabricating advanced waveguide structures in potassium titanyl phosphate (KTP) capable of efficiently generating 25 to 40 mW of frequency converted light in the 395 to 480 nm. The key innovation in this effort is to utilize KTP waveguides in a single-pass frequency doubling device to efficiently produce the desired laser wavelengths and po ...

This NIST Phase II SBIR effort will two low noise single photon detectors using MgO doped LiNbO3 (LN) periodically poled waveguides and a 980nm (or similar appropriate wavelength) pump to up convert 1550nm photons to 600nm to allow for detection by photomultiplier tube (PMT). The key innovation is using low noise periodically poled waveguides with a long wavelength (1800nm) pump leading to higher ...