Award Data

Current scene projection hardware is challenged to simultaneously meet the requirements for high peak temperature (> 2000K), high resolution (2Kx2K), response time < 4 ms, cryogenic and temporally uniform photon flux. MEMS, Resistor arrays, liquid cr...

Automatic speech recognition (ASR) technology is in wide use today and has been successfully integrated into a number of applications. Although there are also many potential applications for automatic speaker identification (SID), SID accuracy rates are generally not sufficient for widespread use in practical applications. For high accuracy ASR and SID, the microphone must be located near the talk ...

Increasing system capabilities in terms of weapon systems, ISR payloads, GNC, etc., enabled by smaller and more capable electronics systems have led to a trend for overall size reduction in military aircraft. This has resulted in a reduction in the avail...

Busek Co. Inc. and The University of Notre Dame propose to develop room-temperature ionic liquids (ILs) that are robust, non-volatile, transparent, radiation hard, and atmospherically tolerant for use in electrolytes for reversible electroplating applica...

ABSTRACT: The objective of this proposal is to demonstrate the feasibility of a flexible, low-cost, integrated and sensitive broad spectrum optical property characterization system. We propose a hyperspectral imager designed for operation in the 300nm 2000nm spectral region with state-of-the-art spectral and spatial resolution through the use of a high density array of high finesse (F = 1000) tuna ...

ABSTRACT: This Phase I STTR project aims to develop a silicon friendly carbon nanotube field effect transistor platform technology with reduced contact resistance and wafer-scale aligned carbon nanotubes towards development of an L-band amplifier. Key innovation nuggets that will be developed include: 1) a wafer scalable process to deposit dense aligned arrays of high purity semiconducting and len ...

ABSTRACT: In this project, we propose to develop the baseline process to form low source-drain contact resistance to the CNTs. This includes finding the right metal stack and annealing recipe to form good ohmic contact to the CNTs. The goal is to achieve a resistance less than 25 k at per nanotube contact. To reach such goal, we will leverage the interfacial dipole alignment of conjugated polyelec ...

ABSTRACT: The hydrocarbon-fueled scramjet is capable of providing hypersonic air-breathing propulsion for high-speed applications. The effective operation of high-speed air-breathing engines (ram- and scram-jets) over a wide range of flow parameters (velocity and altitude) is one of the most technically difficult challenges in the design of hypersonic vehicles. The most promising approach to overc ...

ABSTRACT: The need for improved performance of liquid rocket engines requires efficient wall cooling technologies to mitigate high heat fluxes from hot combustion gases to the engine wall in the thrust chamber. High heat fluxes to the chamber liners can be overcome by fuel film cooling (FFC) of the inside chamber using the liquid propellant. Moreover, the thermal cracking of the fuel creates coke ...

ABSTRACT: Enig Associates, Inc., a small business providing advanced modeling and simulation capabilities to the DoD and DoE, is proposing an innovative and novel electrical approach, using explosive-driven flux compression generators (FCG) to convert explosive chemical energy to electromagnetic energy with very high current output and superb energy conversion efficiency and then Joule heat light ...