DYNAMIC CONTROLS, INC.
| 7060 Cliffwood Pl.
Dayton, OH, 45424 2929
|Firm CFO (or equivalent):|
|POC Contracting Officer (or equivalent)|
|SBC Control ID:|
The objective of the Phase II effort is to develop a prototype Jet Blast Deflector (JBD) actuation system based upon the electric actuation approach investigated in Phase I. This approach uses a vari ...SBIR Phase II 2007 NavyDepartment of Defense
This proposal describes an electrical actuator which uses a hydrostatic transmission to convert the rotary motion of the motor to linear output motion. The hydrostatic transmission provides the gear ...SBIR Phase I 2005 NavyDepartment of Defense
"This proposal presents an approach to achieving faster response and increased reliability for electromechanical actuators, while reducing overall weight and providing improved distribution of the the ...SBIR Phase I 2002 Missile Defense AgencyDepartment of Defense
N/ASBIR Phase II 1999 Air ForceDepartment of Defense
The ability to monitor the operating characteristics of flight control actuators with embedded microprocessors is now feasible and cost effective. Although central computers can be used for the purpo ...SBIR Phase I 1998 Air ForceDepartment of Defense
The proposal presents an investigationto develop new hand controllers for primary flight controls. The effort will gather data on previous and cureent controllers, analyze the data and based upon spec ...SBIR Phase II 1995 Air ForceDepartment of Defense
N/ASBIR Phase I 1994 Air ForceDepartment of Defense
THE OBJECTIVE OF THE PROJECT IS TO DETERMINE A SATISFACTORY METHOD OF CONDUCTING AIRCRAFT LANDING GEAR TESTS IN THE AFWAL FLIGHT DYNAMICS LABORATORY LAND GEAR DEVELOPMENT FACILITY (LGDF) AS AN INTEGRA ...SBIR Phase I 1987 Air ForceDepartment of Defense